Abstract:With the development of wireless communication technology and micro-cell technology, optical-borne microwave technology, specially optical-borne multi-carrier technology has become one of the most important trends for generating high-quality sources. Therefore, the efficient generation of high-quality microwave signals has always been a requirement in wireless communication systems. Due to its low-noise and high-frequency output characteristics, photoelectric oscillator is widely used to generate high-quality microwave frequency sources in communication systems. Combining the advantages of photoelectric oscillator's low-noise output and direct-modulated laser's gain-switching state characteristics, a tunable optical-borne microwave frequency comb scheme based on dual-loop mixing-frequency photoelectric oscillator is proposed in this paper. And a direct-modulated laser operating in a gain-switching state is used to generate the original optical-borne microwave frequency comb signals. The dual-loop adjacent resonant frequencies are separated by two different high-frequency microwave bandpass filters. The beat frequency of adjacent frequencies mentioned above is injected back into laser to form photoelectric resonance, and thus enhancing the generated original optical-borne microwave frequency comb signals. To suppress the side modes caused by long resonant cavity, a polarized dual-loop structure is used in the system, and thus improving the noise characteristics of output signals. After experimental analysis, the dual-loop filtered resonant microwave signals and low-phase-noise microwave comb signals with a frequency interval of 797.4 MHz are all obtained. The microwave output side-mode suppression ratio after polarized dual-loop adjustment is improved to 47 dB. And microwave comb signal's first-order carrier phase noise is lower than -101.7 dBc/Hz at 10 kHz, -115.2 dBc/Hz at 50 kHz. In addition, higher-order carriers all come from the light multiplication of first-order carrier, they share the same low noise characteristics with first-order microwave comb signal. The output power of first-to-fourth, fifth-to-thirteenth order carriers are balanced to 10 dB by photoelectric resonance injection. And their side-mode suppression ratios are all better than 40 dB. Furthermore, theoretically, the comb interval can be adjusted to any frequencies by changing the center frequencies of two high-frequency bandpass microwave filters. Therefore, optical-borne multi-carrier microwave signals are generated efficiently and cost-effectively by this tunable optical-borne microwave frequency comb scheme, and the generated low-noise multi-carrier frequency sources meet the demand of an optical-borne microwave wireless communication system.

Method for the generation of microwave frequency combs based on a Vernier optoelectronic feedback loop

High power flatness and wide spectrum range microwave frequency combs generation based on an actively mode-locked optoelectronic oscillator with intensity feed-forward path

Optical millimeter-wave generation based on multiple modulations in an optical feedback loop

Research on Optical Mutual Injection to Generate Tunable Microwave Frequency Combs

Tunable Microwave Frequency Comb Generation Based on Double-Loop Mixing-Frequency Optoelectronic Oscillator

A Tunable Optoelectronic Oscillator Based on a Dispersion-Induced Microwave Photonic Filter

Tunable and Broadband Microwave Frequency Comb Generation Using Optically Injected Semiconductor Laser Nonlinear Dynamics

An Optical Millimeter-Wave Generation Technique Based on Phase Modulation and Brillouin-Assisted Notch-Filtering

Optical Frequency Combs for Low Phase Noise Microwave Generation

Photonic Generation of Frequency-Tunable Microwave Signals Using an Array of Uniformly Spaced Optical Combs

Broadband electro-optic frequency comb generation in an integrated microring resonator

Tunable Microwave Frequency Comb Generation Via Periodic Relaxation Oscillation in Directly Modulated Laser

Low Noise and Wideband Optical Frequency Comb Generation Based on an Optoelectronic Oscillator

Low Phase Noise Microwave Signal Generation with Microcombs

On the Design of Low Phase Noise and Flat Spectrum Optical Parametric Frequency Comb

Passively stabilized Brillouin fiber laser frequency combs for ultralow-noise microwave generation

Microwave resonator-enabled broadband on-chip electro-optic frequency comb generation

Ultra-low Noise Microwave Signal Generation with an Optical Frequency Comb

Tunable Ultraflat Optical Frequency Comb Generator Based on Optoelectronic Oscillator Using Dual-Parallel Mach–Zehnder Modulator

10 GHz Generation with Ultra-Low Phase Noise via the Transfer Oscillator Technique

Optical Frequency Comb Generation via Cascaded Intensity and Phase Photonic Crystal Modulators