Abstract:The effectiveness of Carbon Fiber Reinforced Polymer (CFRP) seismic-retrofit of circular Reinforced Concrete (RC) bridge piers under vehicular lateral impact loading is addressed in the present work performing experimental tests. Sixteen 1/3 scale RC bridge piers with circular cross-sections characterized by three different configurations of longitudinal and transverse reinforcements were tested with and without CFRP seismic-retrofit. In the first case, tested columns represent common shear-deficient RC bridge piers designed with obsolete design practice or for non-seismic areas. In the second case, CFRP wrapping is applied according to common seismicretrofit practices to increase the shear capacity and ductility of columns. Experimental tests were carried out under static and lateral impact loading with propped cantilever conditions reproducing a typical short-span viaduct bridge pier configuration. In the static tests, the lateral load was applied monotonically through a hydraulic jacket under equivalent impact conditions. In impact tests, the lateral impact load was applied through a colliding truck equipped with a rigid hammer at the typical vehicular impact location adopting two different impact velocities (3 and 4.5 m/s). A critical investigation of the transient dynamic characteristics, damage evolution, and post-impact damage is conducted by comparing the results obtained with and without CFRP seismic-retrofit, and under static and dynamic loading conditions. It is shown that CFRP seismic-retrofitting of circular RC bridge pier can also be effective in reducing the vulnerability under lateral impact loading. The CFRP-retrofit approach adopted in this study meets the requirement of multi-hazard prevention improving the robustness of the bridge. Finally, a semi-empirical equation for predicting the maximum displacement under impact loading is derived based on experimental results. The proposed equation adopts the results of a static test as a proxy for assessing the dynamic behavior allowing for the design of the required shear and flexural load-carrying capacity.

Deteriorated Seismic Capacity Assessment of Reinforced Concrete Bridge Piers in Corrosive Environment

Deteriorated seismic capacity assessment of RC bridge piers in corrosive environment

Effect Of Corroded Surface Morphology On Ultra-Low Cycle Fatigue Of Steel Bridge Piers

Simplified Structural Deterioration Model for Reinforced Concrete Bridge Piers under Cyclic Loading 1

Seismic performance of deteriorating concrete bridges

Probability-Based Performance Degradation Model and Constitutive Model for the Buckling Behavior of Corroded Steel Bars

Machine Learning-based Seismic Fragility Curves for RC Bridge Piers

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Study on time-varying seismic vulnerability and analysis of ECC-RC composite piers using high strength reinforcement bars in offshore environment

Reinforcement Corrosion in RC Hollow Piers: Destructive and Non-Destructive Tests

Data-driven Corrosion Failure Probabilistic Assessment Model for Reinforced Concrete Structures

Performance and damage states assessment of thin-walled steel bridge piers with end-corrosion under earthquake loading

A Combined Experimental-Numerical Framework for Assessing the Load-Bearing Capacity of Existing PC Bridge Decks Accounting for Corrosion of Prestressing Strands

Fragility Assessment of RC Bridges Exposed to Seismic Loads and Corrosion over Time

Numerical investigation of the influence of cross-sectional shape and corrosion damage on failure mechanisms of RC bridge piers under earthquake loading

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

Performance-based seismic resilience and sustainability assessment of coastal RC bridges in aggressive marine environments

Seismic performance evaluation of steel circular hollow section bridge piers with corroded ends

Seismic resilience assessment of extended pile shaft supported coastal bridges considering scour and uniform corrosion effects

Hysteretic model of reinforced concrete bridge piers based on earthquake damage and corrosion from saline soil

Intensity and location of corrosion on the reliability of a steel bridge