Abstract:Soft Open Point (SOP) refers to a power electronic device installed in place of a normally-open point in a distribution network. The application of SOP will greatly promote the economy, flexibility and controllability of the distribution network. However, due to the high investment of SOP and operation cost of switch, the coordinated operation of SOP and switch needs to be considered. In this paper, a coordinated optimization method of SOP and tie switch operation simultaneously based on cost is proposed for the operation of active distribution system. Firstly, this paper builds a coordinated operation optimization model for SOP and switch considering action costs. Then, a conic model conversion is proposed and mixedinteger second-order cone programming is used to solve the model with efficiency and convergence. Finally, case studies on IEEE 33-node test feeder are used to verify the proposed coordinated optimization method. INTRODUCTION The development and application of smart distribution network and renewable resource generation technologies is pushing forward the reform of distribution & utilization pattern and operation management mechanism [1]. As a novel power electronic device, Soft Open Point (SOP), emerges to replace the normally-open point in distribution network. Compared with traditional tie switch, the power flow controlled by SOP is in an accurate and flexible way. It can realize real-time active power flow optimization and reactive power compensation, which effectively responds to the volatility brought by DG and load. However, traditional tie switch cannot be completely replaced by SOP in a short time in terms of the high investment. The operation optimization of distributed network containing both of them needs to be taken into account. Considering the power losses and current surge caused by switching events, the traditional tie switch can’t operate frequently. By contrast, SOP is capable of changing transmitted power and operation state, which offers a feasible solution to overvoltage and overload. In this case, the time series model of coordinated optimization of traditional tie switch and SOP is needed. Foundation item: Support by the Science & Technology Projects of CSG ( KY2014-2-0024 ). Reference [2] studied the basic principle and model of the SOP, while reference [3, 4] carried on the simulation analysis of steady-state and transient characteristics of SOP, respectively, which will provide a foundation for the coordinated optimization for SOP and tie switch. This paper proposes a coordinated optimization method for SOP and tie switch considering action costs. The conic programming is employed to convert the original model into a mixed integer second order conic programming model. The effectiveness of the optimization model and algorithm is verified on the modified IEEE 33-node system. MODELING OF DISTRIBUTION NETWORK COORDINATED OPERATION WITH SOP AND TIE SWITCHES In this section, considering the action costs of tie switch and power losses of SOP, the mathematical model of distribution network coordinated operation with SOP and tie switch is formulated. Objective function This paper takes the minimization of active power losses as the objective function, which is formulated as   SWI,loss NET,loss SOP,loss min min f W W W    (1) The overall active power losses of distribution network are composed of the following three parts. 1) W SWI,loss : equivalent losses of action costs caused by switches

Multi-port Coordinated Control Strategy of SOP in Distribution Network

Optimal Configuration for Soft Open Point Based on Scenario Generation of Wind Power and Photovoltaic Output

Control strategies for active distribution networks based on soft open point

A control strategy for soft open points based on adaptive voltage droop outer-loop control and sliding mode inner-loop control with feedback linearization

A Two-Layer Control Strategy for Soft Open Points Considering the Economical Operation Area of Transformers in Active Distribution Networks

Coordination Control Strategy for Power Management of Active Distribution Networks.

Research on the Application of SOP in Multi-Station Integrated System

Control Strategy of Multi-level Converters for Soft Open Point Applications

An Adaptive Power Control Method for Soft Open Points Based on Virtual Impedance

Research On An Improved Droop Control Strategy For Soft Open Point

Optimized Two-Time Scale Robust Dispatching Method for the Multi-Terminal Soft Open Point in Unbalanced Active Distribution Networks

An Overview of Soft Open Points in Electricity Distribution Networks

Operating principle of Soft Open Points for electrical distribution network operation

Load Shedding Method of Power Restoration of Distribution Network Based on SOP

A Coordinated Optimization Method of SNOP and Tie Switch Operation Simultaneously Based on Cost in Active Distribution Network

A Control Strategy for Enhanced Operation of SNOP under Transient Disturbances and Network Faults

Topology Selection and Operation Strategy Design of the Soft Open Point in Looped Distribution Networks

Switching Technology of Three-Terminals Soft Open Point Control Mode

Real-Time Coordinated Control of Low-Voltage DC Distribution Network With Soft Opening Point

Delta-Type Serial Shunt Soft Normally-Open Points with Wide Power Flow Regulation Range in Distributed Network

Resilience-Oriented Optimal Allocation of Multi-Port Soft Open Point in Distribution Network