Abstract:A novel radial sandwich radial bending composite transducer is proposed based on the increasing amplitude of bending waves in the structure of an acoustic black hole (ABH). The transducer consists of a radial sandwich circular ring transducer and an outer acoustic black hole structure. The existence of ABH structure realizes the conversion between radial vibration and bending vibration of the transducer, and improves the acoustic radiation performance of the transducer. Based on the onedimensional acoustic black hole bending vibration theory, the bending vibration equation of the annular ABH structure is given. An analytical model of ABH structure bending vibration was established by using the method of geometrical-acoustics, and the eigen frequency of its bending vibration was given. The relationship between the electromechanical conversion performance and the size of the transducer was discussed using finite element method, the results show that when the eigen frequency of the bending vibration of the ABH structure is close to the resonant frequency of the transducer, the electromechanical coupling coefficient of the transducer reaches the maximum value. The radiation sound pressure field, radiation sound intensity, and radiation directionality of the transducer in the air were also analyzed by the finite element method. The results indicate that the presence of ABH structure can improve the electromechanical conversion performance of the bending vibration of the transducer, enhance the acoustic radiation performance of the transducer, make the transducer exhibit radiation directionality and the lower order of the bending vibration mode of the ABH structure, the stronger radiation directionality of the transducer towards the left and right sides. Finally, we made a prototype transducer, in order to verify the accuracy of the simulation and theory, we carried out transducer electrical impedance experimental test and vibration mode test. The measured results are in good agreement with the simulation results. The displacement distribution of the radiation surface of the transducer at resonance frequency is measured, which verifies the bending vibration modes of the ABH structure. This type of transducer is expected to be used as acoustic projector in the air or water.

Investigation on Low-Frequency Broadband Characteristics of Three-Dimensional Acoustic Black Hole Superstructures

A composite acoustic black hole for ultra-low-frequency and ultra-broad-band sound wave control

Broadband sound absorption using acoustic black holes with micro-perforated panels

Design, analysis, and experimental validation of a sonic black hole structure for near-perfect broadband sound absorption

Sound absorber based on a sonic black hole and multi-layer micro-perforated panels

A novel periodic beam with multilayer acoustic black holes for deep sub-wavelength vibration attenuation

Ultra-low frequency broadband gap optimization of 1D periodic structure with dual power-law acoustic black holes

Phononic Thin Plates with Embedded Acoustic Black Holes

Multimodal Local Resonators for Low-Frequency Amelioration of Acoustic Black Holes

Enhanced sound absorption with the combined sonic black holes

A New Type of Artificial Structure to Achieve Broadband Omnidirectional Acoustic Absorption

Convergence performance of flexural wave in the unconventional acoustic black hole

Multilayer structures for high-intensity sound energy absorption in low-frequency range

A broadband and low-frequency sound absorber of sonic black holes with multi-layered micro-perforated panels

Vibro-Acoustic Analysis of Rectangular Plate-Cavity Parallelepiped Coupling System Embedded with 2D Acoustic Black Holes

Design of radial sandwich radial-bending composite transducer based on acoustic black hole theory

Wave trapping by acoustic black hole: Simultaneous reduction of sound reflection and transmission

Periodic Acoustic Black Holes to Mitigate Sound Radiation from Cylindrical Structures

Aperiodic Two-Dimensional Acoustic Black Holes for Broadband Vibration Attenuation in a Strip

Embedded periodically ABHs and distributed DVAs for passive low-frequency broadband vibration attenuation in thin-walled structures

Research on the Low-Frequency Sound Absorption Characteristics of Coiled Helmholtz Cavity Acoustic Metamaterials