Abstract:Abstract The data acquisition system is widely used in electronic measuring instruments, for example, the oscilloscope . The development direction of the oscilloscope reflects the research status and development trend of the data acquisition system. Currently, the index of oscilloscopes is progressing toward a high sampling rate, and the performance of the analog‐to‐digital converter (ADC) has become the main bottleneck to improve the sampling rate of the acquisition system. The alternate sampling technology entails multichannel low sampling rate ADCs to achieve high sampling rate data acquisition through parallel sampling and realize data reconstruction through software. The sampling clock is the most important and difficult part of the system. For ADCs with the 100‐GS/s sampling rate and 10‐bit resolution, the jitter of the sampling clock needs to be in sub‐100 fs along with multiple phases. Based on the principle of injection locking, a 150‐GS/s sampling clock is proposed in this paper, which is implemented in a 0.15‐μm GaAs process, and the 50‐GHz locking range is achieved. The measurement results show that the sampling frequency is 150 GS/s, the root mean square (RMS) jitter is 63 fs with the integrated range from 1 kHz to 10 MHz, and the phase noise can meet the sampling requirements of the 10‐bit oscilloscope, which can provide a clocking scheme for small and low‐power ultrahigh‐speed oscilloscope.

An Analog Front End Design For Gsps Oscilloscope

A Front-End Circuit With 16-Channel 12-Bit 100-Ksps Rc-Hybrid Sar Adc For Industrial Monitoring Application

A High Performance 2-Ghz Direct-Conversion Front End with Single-Ended RF Input in 0.13 Um CMOS

Design of rf front end for cavity beam position monitor based on ics *

A Design of EES Analog Pre-processing Circuit

A High-Speed Analog Front-End Circuit Used in A 12bit 1gsps Pipeline Adc

High Linearity Front- End Circuit for RF Sampling ADCs with Nonlinear Junction Capacitor Cancellation

Design of Board Dynamic Range and Low Distortion Analog Front-end

A Gain and Bandwidth Individually Tunable ExG Analog Frontend with 516nV<sub>rms</sub> Noise for Flexible Biomedical Sensors

A 0.18- $\mu\hbox{m}$ CMOS GFSK Analog Front End Using a Bessel-Based Quadrature Discriminator with On-Chip Automatic Tuning

A low power analog front-end for portable biopotential acquisition systems

The Analog Front-end Prototype Electronics Designed for LHAASO WCDA

Design for Digital Oscilloscopes with Seamless Measurement Capability

A 15.5-ENOB 335 mV<sub>PP</sub>-Linear-Input-Range 4.7-G-Input-Impedance CT-M Analog Front-End With Embedded Low-Frequency Chopping

A 10‐MHz to 50‐GHz low‐jitter multiphase clock generator for high‐speed oscilloscope in 0.15‐μm GaAs technology

A 66-Db Sndr, 8-Mu W Analog Front-End For Ecg/Eeg Recording Application

Design of an Analog Front-End for Ambulatory Biopotential Measurement Systems

Design of the Digital Oscilloscope Used in Fault Detection

A 1.6-Gsps High-Resolution Waveform Digitizer Based on a Time-Interleaved Technique

A 6-Ghz Bandwidth Input Buffer Based on AC-Coupled Flipped Source Follower for 12-Bit 8-Gs/s ADC in 28-Nm CMOS

Hardware Design of 1GS/s Virtual Oscilloscope