Abstract:UNLABELLED:A general model has been developed for analyzing the removal of volatile organic compounds (VOCs) by photocatalytic oxidation (PCO) reactors, taking into consideration of the photocatalytic (surface) reaction and the convective mass transfer coefficients including allowance for their spatial dependence. On this basis, a novel insight into VOC removal performance of PCO reactors is presented. The key parameter for evaluating PCO reactor VOC removal performance is the number of the mass transfer unit (NTU(m)), which is shown to be a simple linear product of three dimensionless parameters: the ratio of the reaction area to the cross-sectional area of the flow channel (A*), the Stanton number of mass transfer (St(m)), and the reaction effectiveness (eta). The A* represents the geometric and structural characteristic of a PCO reactor. The St(m) shows the synergistic degree of alignment between the fluid and mass flow fields, and reflects the convective mass transfer rate of the reactor. The eta, describes the relative intensity between the PCO reaction rate and the mass transfer rate. By using the relationship and the parameters, the influence of various factors on the VOC removal performance, the bottleneck for improving the performance and design of a PCO reactor can be determined. Three examples are used to illustrate the application of our proposed model. It is found that the VOC removal bottleneck is the reaction rate for honeycomb type reactor, while mass transfer rate for light-in-tube type reactor. With six fins the fractional conversion of a light-in-tube reactor increases about 70% relative to the one without any fins.PRACTICAL IMPLICATIONS:Indoor air quality problem caused by volatile organic compounds (VOCs) have annoyed people for many years. Photocatalytic oxidation (PCO) appears to be a promising technique for destroying VOCs in indoor air. With the model and the novel insight presented in this paper, the influence of various factors on the VOC removal performance can be determined. And the bottleneck for improving the performance of a PCO reactor can be easily identified. These are helpful for designing high performance PCO reactors and optimizing their operative performance.

A VARIATIONAL PRINCIPLE FOR THE PHOTOCATALYTIC NOx ABATEMENT

A Novel Numerical Method Coupling CFD with PSO Vs. a Mathematical Approach in the Modeling of Photocatalytic Degradation of NO

Numerical Verification for a New Type of UV Disinfection Reactor

A novel numerical method coupling CFD with PSO vs. mathematical approach in the modeling of photocatalytic degradation of NO

Progress in Numerical Simulation of Turbulent Reacting Rate of NO Formation in Turbulent Combustion

Multivariate modeling of intrinsic kinetics for gas-solid heterogeneous photocatalytic reaction: A general method for different pollutant-photocatalyst systems

Photocatalytic NOx abatement: Recent advances and emerging trends in the development of photocatalysts

An Improved NO Prediction Model for Large Eddy Simulation of Turbulent Combustion

THE HIGH VOLTAGE PULSED CORONA APPROACH FOR THE TREATMENT OF NOx

Study on Apparent Kinetics of NO Oxidized by H2O2 with UV-enhancement

Photocatalytic NO removal: complete oxidation and reduction reaction for by-product inhibition and end-product recovery

Research advance in non-thermal plasma induced selective catalytic reduction NO_x with low hydrocarbon compounds

Novel Insight into VOC Removal Performance of Photocatalytic Oxidation Reactors.

Recent Developments on Gas‐Phase Volatile Organic Compounds Abatement Based on Photocatalysis

Experimental and computational study on removal of nitric oxide using NH2-MIL-125: Revisiting removal mechanism

Numerical Simulation and Experiment for Soot and NOx Emission in Diesel Engine

Advances in Catalytic Removal of NO X under Lean-Burn Conditions

Simple photochemical modelling of NOX pollution in a street canyon

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

CFD Modeling of a UV-LED Photocatalytic Odor Abatement Process in a Continuous Reactor.

Oxygen vacancy engineering of photocatalytic nanomaterials for enrichment, activation, and efficient removal of nitrogen oxides with high selectivity: a review