Abstract:The objectives of this study were to establish the method of evaluating wood mechanical properties by acoustic nondestructive testing at standing trees and at logs of a Chinese fir (Cunninghamia lanceolata (Lamb.) Hook.) plantation, and to compare three acoustic nondestructive methods for evaluating the static bending modulus of elasticity (MOE), modulus of rupture (MOR), and compressive strength parallel-to-grain (σc) of plantation wood as well. Fifteen Chinese fir plantation trees at 36 years of age were selected. Each tree was cut into four logs, for which three values of dynamic modulus of elasticity, i.e., Esw, of the north and south face based on stress waves to assume the measuring state of the standing tree, Efr, longitudinal vibration, and Eus, ultrasonic wave, were measured in the green condition. After log measurements, small specimens were cut and air-dried to 12% moisture content (MC). Static bending tests were then performed to determine the bending MOE and MOR, and compressive tests parallel-to-grain were made to determine σc. The bending MOE of small clear specimens was about 7.1% and 15.4% less than Esw and Eus, respectively, and 11.3% greater than Efr. The differences between the bending MOE and dynamic MOE of logs as determined by the three acoustic methods were statistically significant (P < 0.001). Good correlation (R = 0.77, 0.57, and 0.45) between Esw, Efr, and Eus and static MOE, respectively, were obtained (P < 0.001). It can be concluded that longitudinal vibration may be the most precise and reliable technique to evaluate the mechanical properties of logs among these three acoustic nondestructive methods. Moreover, the results indicate that stress wave technology would be effective to evaluate wood mechanical properties both from logs and from the standing tree.

Wood Physical-mechanical Properties of Acrocarpus fraxinifolius Wight et Arn

Characterization and Prediction of Mechanical and Chemical Properties of Luanta Fir Wood with Vacuum Hydrothermal Treatment

Analysis and Comparison on Anatomic Features and Properties of 4 Acacia Species

Physico-Mechanical and Anatomical Properties of Normal and Tension Woods of Terminalia Superba (Engl. & Diels)

Evaluating Mechanical Properties of Chinese-fir with Ultrasonic Nondestructive Testing

Wood Anatomical Properties and Variation of Eucalyptus urophylla×Eucalyptus grandis Families

Mechanical properties assessment of Cunninghamia lanceolata plantation wood with three acoustic-based nondestructive methods

Compressive Mechanical Properties of Larch Wood in Different Grain Orientations

Characterizing strength and fracture of wood cell wall through uniaxial micro-compression test

Mechanical Properties of Wood: A Review

Intra-Ring Wood Density and Dynamic Modulus of Elasticity Profiles for Black Spruce and Jack Pine from X-ray Densitometry and Ultrasonic Wave Velocity Measurement

Understanding the mechanical strength and dynamic structural changes of wood-based products using X-ray computed tomography

Experimental Study on Properties of Aged Wood of Ancient Architecture

Studies Upon the Structure and Properties of Cotton/Wood Pulp Blends Cellulose Acetate Fiber

Effect of Resin Content on the Structure, Water Resistance and Mechanical Properties of High-Density Bamboo Scrimbers

Evaluation of Drought Tolerance of Acrocarpus fraxinifolius

APPARENT DENSITY AS AN ESTIMATOR OF WOOD PROPERTIES OBTAINED IN TESTS WHERE FAILURE IS FRAGILE

Comparison of Wood Physical and Mechanical Traits Between Major Gymnosperm and Angiosperm Tree Species in China

Full elastic properties characterization of wood by ultrasound using a single sample

Identification of anisotropic vibrational properties of Padauk wood with interlocked grain

Mechanical properties of poplar (NL-3412) branches