Low-cost Microbiological Purification Using a New Ceramic Disk Filter Functionalized by Chitosan/tio2 Nanocomposites

Ziqing Xu,Guohe Huang,Chunjiang An,Jing Huang,Xiujuan Chen,Xiaying Xin,Pei Song,Renfei Feng,Yongping Li
DOI: https://doi.org/10.1016/j.seppur.2020.116984
IF: 8.6
2020-01-01
Separation and Purification Technology
Abstract:The intaking of water with undesired substances may cause many water-borne diseases. It is required to develop efficient and low-cost water purification technologies for developing countries. In this study, a new ceramic disk filter functionalized by chitosan/TiO2 nanocomposites (CT-CDF) for bacterial removal from drinking water was investigated. The characterization results showed that the chitosan/TiO2 nanocomposites were attached to the surface of CDFs. The optimal conditions for producing CT-CDFs were 0.2 g of chitosan, 0.05 g of TiO2, and 0.04 g of coating amount, respectively. The factorial analysis indicated that the illumination time and lamp power promoted the reduction of E. coli, but influent E. coli concentration showed a negative effect. There was an interaction between lamp power and influent E. coli concentration. The bacterial removal of CT-CDFs was due to the retention by irregular pores in CT-CDF, the cell membrane damage caused by the attached chitosan/TiO2 nanocomposites, and the oxidative stress in cells from ROS generated by nano-TiO2. Prolonging illumination time and increasing lamp power can promote the photocatalysis, resulting in the enhanced removal efficiency of CT-CDFs. The results of this study can provides not only an insight into the bacterial removal involving multiple mechanisms, but also an economic-feasible solution for resolving the water safety issues in developing countries.
What problem does this paper attempt to address?