Abstract:Two acrylate monomers with six-member cyclic ortho ester groups, i.e., 2-(1,3-dioxan-2-yloxy)ethyl acrylate (DEA) and 2-(5,5-dimethyl-1,3-dioxan-2-yloxy) ethyl acrylate (DMDEA), were synthesized. These two monomers were copolymerized with an oligo(ethylene glycol) acrylate (OEGA) under atom transfer radical polymerization conditions to afford two series of thermoresponsive copolymers, poly(DEA-co-OEGA)s and poly(DMDEA-co-OEGA)s. All the copolymers were soluble in water to form transparent solutions at low temperature, however, some of them exhibited association behaviors below the cloud point (CP) as evidenced by (HNMR)-H-1, dynamic light scattering (DLS) and fluorescence method. The aggregation tendency of the copolymers depends on their composition as well as the structure of the ortho ester units. With a similar composition, poly(DMDEA-co-OEGA) showed a stronger aggregation tendency than poly(DEA-co-OEGA). In addition, increasing molar content of the ortho ester units in a copolymer promoted its aggregation in water. Thermally induced phase transitions of these copolymers were studied by various methods including turbidimetry, temperature-dependent (HNMR)-H-1, DLS, and microscopy. The results indicate that CP of the copolymers increased with increasing the content of OEGA units, but the changing behaviors of CP were rather different for two types of copolymers, which can be ascribed to the difference in hydrophobicity of the ortho ester units. Little hysteresis was observed for the copolymers with more OEGA units while those with more alto ester units showed significant hysteresis probably due to the hydrophobic character of the ortho ester. The formation of coacervate droplets above CP reveals that the copolymers underwent a liquid liquid phase separation upon heating. pH-dependent hydrolyses of the copolymers were studied by turbidimetry and H-1 NMR methods. The hydrolysis rate depends greatly on pH and the hydrophilic/hydrophobic balance of the copolymers: lower pH and more hydrophilic character resulted in a faster hydrolysis rate. Finally, this type of acid-labile thermoresponsive copolymers and the acid-catalyzed hydrolysis products have low cytotoxicity.

Thermoresponsive Molecular Brushes with Propylene Oxide/Ethylene Oxide Copolymer Side Chains in Aqueous Solution

Chain Conformation of a New Class of PEG-based Thermoresponsive Polymer Brushes Grafted on Silicon As Determined by Neutron Reflectometry.

Thermoresponsive Hyperbranched Polymers Via in Situ RAFT Copolymerization of Peg‐based Monomethacrylate and Dimethacrylate Monomers

Synthesis and biological properties of water-soluble polyphenylthiophene brushes with poly(ethylene glycol)/polyzwitterion side chains

Synthesis and thermoresponsive properties of polymethacrylate molecular brushes with oligo(ethylene glycol)-block-oligo(propylene glycol) side chains

Synthesis, Aggregation and Adsorption Behaviour of a Thermoresponsive Pentablock Copolymer

Preparation and Performance Study of HTPB-g-(PNIPAM/PEG) Thermoresponsive Polymer Brush

Temperature Dependence of the Surface and Volume Hydrophilicity of Hydrophilic Polymer Brushes

The conformation of thermoresponsive polymer brushes probed by optical reflectivity

Studies of Thermoresponsive Polymer Brushes by Atomic Force Microscopy and Quartz Crystal Microbalance with Dissipation

On the Two-Step Phase Transition Behavior of the Poly(N-isopropylacrylamide) (PNIPAM) Brush: Different Zones with Different Orders

Modelling thermoresponsive polymer brush by mesoscale computer simulations

Thermoresponsive Star Triblock Copolymers by Combination of Rop and Atrp: from Micelles to Hydrogels

Self-Assembly of Molecular Brushes with Polyimide Backbone and Amphiphilic Block Copolymer Side Chains in Selective Solvents

Synthesis and Properties of a Coil- g -Rod Polymer Brush by Combination of ATRP and Alternating Copolymerization

Biocompatible Thermoresponsive Polymers with Pendent Oligo(Ethylene Glycol) Chains and Cyclic Ortho Ester Groups

Synthesis, Characterization, Crystalline Morphologies, and Hydrophilicity of Brush Copolymers with Double Crystallizable Side Chains

(PAA-g-PS)-co-PPEGMEMA asymmetric polymer brushes: synthesis, self-assembly, and encapsulating capacity for both hydrophobic and hydrophilic agents

Static and dynamic properties of the interface between a polymer brush and a melt of identical chains

Optically Active Thermosensitive Amphiphilic Polymer Brushes Based on Helical Polyacetylene: Preparation Through "click" Onto Grafting Method and Self-Assembly

Effect of Molecular Structure on Thermoresponsive Behaviors of Pyrrolidone-Based Water-Soluble Polymers