Abstract:In the present paper, cracking sequence of high-strength engineered cementitious composite with the characteristic of low drying shrinkage (LSECC) under tension was experimentally studied by continually photographing during loading. The specific objective is to investigate the development of crack opening of each individual crack occurred during loading. Four Engineered cementations composite mixtures with water to binder ratio of 0.20, 0.25, 0.30, and 0.35 (LSECC-0.20, LSECC-0.25, LSECC-0.30, and LSECC-0.35) were used in the tests. Using the photographers taken during the test, crack width of each crack occurred during loading are determined according to the difference between solid material and crack on gray level. The test results show that cracks in ECC under tensile load are formed according to a temporal sequence. The opening width of each crack grows in a controllable and gradual manner with the increase of tensile strain. At a given strain level, crack width of different crack is not equal and the distribution of crack width is affected by matrix strength of the composite. Maximum crack width and the tensile strain capacity at the moment may be utilized to characterize the tensile performance of the composite that can guarantee both of tensile ductility and long-term durability. As maximum crack width equals 60 μm, at which the permeability of ECC may not be influenced by the cracks, higher strength ECC with water to binder ratio of 0.20 and 0.25 (LSECC-0.20 and LSECC-0.25) shows obvious higher tensile strain capacity and more cracks of narrow opening. By contrast, lower strength ECC with water to binder ratio of 0.30 and 0.35 (LSECC-0.30 and LSECC-0.35) shows relatively lower tensile strain and fewer cracks of narrow crack opening as crack width is limited below 60 μm. With the increase of tensile strain and the maximum crack width, much wider cracks (larger than 60 μm) are formed in lower strength ECC comparing to that of higher strength ECC.

Stress Strain Properties of Engineered Cementitious Composites (ECC) Exposed to Sulfate Dry Wet Cycle

Study on dynamic compression properties of ultra-high toughness cementitous composites under cyclic wetting and drying of salt spray

Compressive Behavior of Engineered Cementitious Composites under High Strain-Rate Loading

Long-term Properties and Microstructure Change of Engineered Cementitious Composites Subjected to High Sulfate Coal Mine Water in Drying-Wetting Cycles

Monitoring and Modeling the Damage Evolution in Engineered Cementitious Composites Subjected to Sulfate Attack Through Continuous Ultrasonic Measurements

Influence of free water on compressive fatigue properties of ECC

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Effect of Low-Stress Fatigue on the Off-Crack-Plane Fracture Energy in Engineered Cementitious Composites

Crack Propagation and Flexural Behaviour of Rc Beams under Simultaneous Sustained Loading and Steel Corrosion

High-strength seawater sea-sand Engineered Cementitious Composites (SS-ECC): Mechanical performance and probabilistic modeling

Seawater sea-sand engineered/strain-hardening cementitious composites (ECC/SHCC): Assessment and modeling of crack characteristics

Numerical simulation on the crystallization-induced mechanical response in hardened cement paste under external sulfate attack

Stress–Strain Properties and Gas Permeability Evolution of Hybrid Fiber Engineered Cementitious Composites in the Process of Compression

Mechanical strength model of engineered cementitious composites with freeze–thaw damage based on pore structure evolution

Combined effects of sulfate attack under drying–wetting cycles and loading on the fatigue behavior of concrete

Mechanical properties and crack width control of seawater coral sand ECC

Evaluation of mechanical and durability properties of engineered cementitious composites exposed to sulfate attack and freeze–thaw cycle

Mapping of cracking sequence of polyvinyl alcohol-steel hybrid fiber reinforced high-strength engineered cementitious composite under uniaxial tension

Cracking Load of High Strength ECC-steel Composite Bridge Deck with Impact of Shrinkage Stress—test and Simulation

Preliminary Analysis of the Ductility and Crack-Control Ability of Engineered Cementitious Composite with Superfine Sand and Polypropylene Fiber (SSPP-ECC)

Experimental investigation on seismic performance of plain engineered cementitious composite beams