Abstract:The deterioration law of the system will usually be assumed to be Markovian, that is, the future process of the system depends only on its state at the present time and not on its past history. This model has been suggested by Klein [1]. There are at least two good reasons for describing deterioration by a Markov model. Firstly, if each component is approximately subject to an exponential failure law, the complete system can be described approximately by a Markov process. Secondly, the first order approximating description of many physical systems contain no predictive value. Markov process is the stochastic equivalent of this type of process. The theory of Markov process is the most popular way to model equipment deterioration and maintenance under the CBM strategies, it generally classified as discrete time Markov chains and continuous-time Markov chains. Christer [2]developed the delay time model, and Jardine [3] used the proportional hazards model to optimize a mine haul truck wheel motor’ condition monitoring program, and Grall et al. [4] used the models based on gamma process. But there is little attention has been paid to CBM modeling of deteriorating systems with multiple different components which have multistate. In fact, dividing the system deterioration into several discrete states is more practical than describing the deterioration condition by a single scalar continuous variable. Endrenyi et al.[5] classified the equipment deterioration into four stages: initial, minor deterioration, major deterioration, and failure. Later the continuous Markov chain process can be generalized in a natural way as follows. According to Tai et al.[6], failure can be distinguished into random failure and deterioration failure. For most equipment, deterioration failure grows gradually with time, occurres due to deterioration or aging mechanisms. However random failure results from other causes not associated with typical aging. In this study, both random failure and failure due to deterioration are considered. In the case of a multistate system, the concept corresponding to the concept of reliability in a binary system is the state distribution. Many practical systems can perform their intended functions at more than two different levels, ranging from working to completely failed. Sim et al.[7] introduced the exponential device failure in a condition maintenance model. For most aforementioned modeling strategy, the stochastic behavior of individual component without repairing is modeled by homogenous Markov process with the assumption that the transition time between any pair of states is exponentially distributed. However, this is not generalized case and transition time between component states may follow other distributions. For this reason, we formulate the semi-Markov decision process (SMDP) model for the condition based maintenance problem. This model based on the assumption that the component state deteriorating process can be captured by Markovian models, and the sojourn time of the state is not exponentially distributed.

Reliability Performance for Dynamic Multi-State Repairable Systems with K Regimes

Reliability Performance for Dynamic Systems with Cycles Ofkregimes

Reliability of Multi-State Systems with Free Access to Repairable Standby Elements

Reliability analysis of Markov history-dependent repairable systems with neglected failures

Markov Repairable Systems With History Dependent Up And Down States

A Stochastic Model on One-Unit Repairable Systems with Multiple Degenerative States.

Reliability assessment for multi-state systems under a dynamic load-sharing strategy

On Multi-State System with Interval-Valued States under Preventive Maintenance and Minimal Repairs

Resilience analysis of multi-state systems with time-dependent behaviors

Reliability Modeling for Systems Degrading in K Cyclical Regimes Based on Gamma Processes

Selective maintenance of multi‐state systems with the repairperson fatigue effect and stochastic break duration

Evaluation of Reliability Function and Mean Residual Life for Degrading Systems Subject to Condition Monitoring and Random Failure

Dynamic Loading and Condition-Based Maintenance Policies for Multi-State Systems with Periodic Inspection

A Deep Reinforcement Learning Approach to Dynamic Loading Strategy of Repairable Multistate Systems

Reliability Analysis for Repairable Multistate Two-Unit Series Systems when Repair Time Can Be Neglected

Dynamic Reliability Assessment for Multi-State Systems Utilizing System-Level Inspection Data

Condition-based Maintenance Optimization for Multistate Systems with Semi-Markov Decision Process

Reliability analysis of multi-state manufacturing systems based on performance degradation

STATE TRANSITION MODEL OF A DISCRETE-TIME SERIAL REPAIRABLE SYSTEM

Dynamic Reliability Assessment for Multi-State Degraded Systems

A Reliability Model for Systems Subject to Mutually Dependent Degradation Processes and Random Shocks under Dynamic Environments.