Abstract:In this paper, numerical simulations of single-jet impingement cooling and double-jet impingement cooling processes of heated L-shaped steel are carried out using the VOF model. The SIMPLEC pressure–velocity coupling algorithm and realizable k-ε model are used for the solution. The effects of jet position, water flow, and jet distance in the single-jet condition are analyzed in the simulations. The distributions of impact pressure, turbulence kinetic energy, and Nusselt number were obtained, as well as the variation of the peak values of these three factors with the jet position, water flow, and jet distance. The water flow rate is 3–11 L/min, and the jet distance is 5–25 cm. The effect of the distance between the two nozzles on the jet cooling uniformity under the dual jet condition was also analyzed. The distance between the two nozzles was 15–45 mm. The results showed that the variation of water flow rate had a greater effect on the ability of jet cooling compared with the jet position and jet distance, and the heat transfer efficiency also increased gradually with the increase of water flow, but the increased rate of heat transfer efficiency decreased gradually. When the flow rate increased from 3 to 11 L/min, the maximum instantaneous cooling rates at 1/4 of the thickness of the short side upper side, long side upper side, short side lower side, and long side lower side positions increased by 38.9%, 48.5%, 48.2%, and 32.9%, respectively. To ensure that the jet does not shift, the jet distance should be less than or equal to 10 cm. In the case of the double jet, the nozzle distance is 1.5 cm, and the cooling uniformity of the cooling area between the two nozzles is better. The peak Nusselt number in the cooling area of each part under the double jet cooling condition increased by 5%, 9.4%, 10.2%, and 13.3%, respectively, compared with the single jet.

Numerical Simulation of the Effects of Air Knives on Coating Thickness

Numerical investigation of multiple-slot jets in air-knife wiping

Numerical simulation and experimental study of strip steel jet cooling

Effects of gas property on quality of NiCoCrAlY coating by cold gas dynamic spraying

Effect of baffle on flow and pressure fields of strip steel edge in the continuous hot-dip galvanizing process

Planar Jet Stripping of Liquid Coatings: Numerical Studies

Numerical Analysis of the Activated Combustion High-Velocity Air-Fuel Spraying Process: A Three-Dimensional Simulation with Improved Gas Mixing and Combustion Mode

Investigation of the Gas‐Jet Wiping Process − Two‐Phase Large Eddy Simulations Elucidate Impingement Dynamics and Wave Formation on Zinc Coatings

Numerical Simulation of Fluidized Bed Coating Process Considering Particle Abrasion

Numerical Simulation and Analysis of Metal Fused Coating Forming

Numerical simulation of single-jet impact cooling and double-jet impact cooling of hot-rolled L-shaped steel based on multiphase flow model

Numerical Study on the Heat Transfer of Confined Air-Jet Quenching of Steel Sheets

Effect of zinc vapor forces on spattering in partial penetration laser welding of zinc-coated steels

Experimental Study on the Coating Removing Characteristics of High-Pressure Water Jet by Micro Jet Flow

Study of Flow and Zinc Dross Removal in Hot-Dip Galvanizing with Combined Traveling Magnetic Field

NUMERICAL INVESTIGATION OF HVAF-SPRAYED Fe-BASED AMORPHOUS COATINGS

Numerical Simulation of Gas Quenching Process of Workpiece

Numerical Simulation of CO2 Used for Slag Splashing Process in Converter

Numerical simulation methodology of multi-layer Kevlar 49 woven fabrics in aircraft engine containment application

Numerical simulation of the blade coating processes using viscoelastic fluid with heat transfer analysis

Dynamic Numerical Simulation of Curved Surface Coating Trajectory Based on STL Slicing Algorithm