Abstract:The non-associated flow rule (non-AFR), which has been proved with advantages in accurately predicting yield stress components and Lankford coefficients, has different definitions for yield function and plastic potential function. Currently, there are two typical approaches to determine the plastic strain for non-AFR, one is called simple method which still uses the equivalent plastic strain (EPS) to calculate the plastic strain tensor, while the other is called full method which adopts the plastic compliance factor. Many researchers prefer to adopt the simple method in calculating the plastic strain due to its higher computation efficiency and its acceptable accuracy like the full method for some materials. However, the limitation and application condition of the simple method are still ambiguous. In the present work, a restriction for calculating the parameters in plastic potential function for the simple method is clarified and the limitation of the simple method has also been investigated. It is found that if the relative error of the difference between the yield function value and that of plastic potential function is within ±5% and hardening exponent is in the range of 0.1–0.3, the maximum absolute value of the relative error of the stress predicted by the simple method can be controlled less than 1.6%. Besides, an effective approach is introduced to reduce the error of the stress predicted by these two methods, which can improve the applicability of the simple method for those materials with the relative error of the difference between the value of yield function and that of plastic potential function is less than 10%. In order to have deeper understanding about their applicability, the two methods are compared under uniaxial tension along different orientations for AA2090-T3 and AA2008-T4 with the fully implicit return-mapping scheme. Fracture simulations of AA2090-T3 have also been conducted by introducing different methods. The results show that during the loading in transverse direction, the difference of EPSs predicted by these two methods is very small for AA2008-T4, while for AA2090-T3, the EPS predicted by the simple method is almost twice of that calculated by the full method. This further indicates that the applicability of the simple method mainly depends on the characteristics of materials.

Residual deflection of aluminum beams

Inelastic Deformation Analysis of Aluminum Bending Members

Predicting deflection of retrofitted reinforced concrete beams

Lateral-torsional Buckling Resistance of Aluminium I-beams

A Nonlinear Theory for CFRP Strengthened Aluminum Beam

Experimental Study and Finite Element Analysis on the Local Buckling Behavior of Aluminium Alloy Beams under Concentrated Loads

EXPERIMENTAL INVESTIGATION AND FINITE ELEMENT ANALYSIS OF LOCAL-OVERALL BUCKLING BEHAVIOR OF ALUMINIUM ALLOY BEAMS

Local Buckling Analysis of Aluminum I Section Beams

Analysis of lateral stability of I-section aluminum beams

A Theory of Nonlinear Finite Element Analysis

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Experimental and numerical investigation on plasticity and fracture behaviors of aluminum alloy 6061-T6 extrusions

Experimental study on the lateral stability of aluminum bending members

A modeling of residual stress in stretched aluminum alloy plate

A closed-form structural stress-strain relation and implications on plastic design limits in codes and standards

Influencing Factors Analysis of Residual Deformation of Doubly Symmetric Stainless Steel Flexural Members

Deflection of a Composite Steel-Concrete Beam Subjected to a Fatigue Load

The Plastic Behavior in the Large Deflection Response of Fiber Metal Laminate Sandwich Beams under Transverse Loading

Experimental and numerical evaluations of the distribution and effect of roll-forming residual stress on CFS sigma beams

On the Calculation of Plastic Strain by Simple Method under Non-Associated Flow Rule

Nonlinear finite element analysis of reinforced concrete beams strengthened by fiber-reinforced plastics