Abstract:Most of the existing studies on acid corrosion of concrete have focused on the mechanical behavior of concrete structures under monotonic load or without load. To investigate the mechanical properties of in-service concrete components under cyclic load in an acid corrosion environment, six groups of concrete prism specimens with different acid corrosion degrees (corrosion duration) were designed and prepared by the accelerated corrosion test method. The monotonic and cyclic axial compression load tests on these specimens were conducted to investigate the effects of corrosion degree on the mechanical properties of concrete specimens. The experimental results indicated that hydrochloric acid corrosion has obvious effects on the failure characteristics and mechanical properties of concrete. The surface of corroded concrete was easier to crack and spall under load, and the concrete spalling area enlarged as the acid corrosion duration increased. The compressive capacity of concrete specimens reduced rapidly with the increase in corrosion duration. The stress–strain envelope curves for concrete with different corrosion duration under cyclic load were essentially similar to that of concrete under monotonic load. The degradation rate of the descending section for the stress–strain curves of corroded concrete under cyclic load was much larger than that under the monotonic load due to the accumulation of internal damage in concrete. The peak strain and ultimate strain of corroded concrete increased significantly with the increase in corrosion duration and enhanced by 55.7% and 77.9%, respectively, compared with the uncorroded concrete, whereas the peak stress and elastic modulus rapidly decreased and reduced by 53.3% and 74.1%, respectively. Moreover, based on the strength degradation depth, the concept of effective bearing cross-sectional area ratio was proposed to characterize the corrosion degree of concrete, and the correction coefficient of descending section for the effective bearing cross-sectional area ratio was introduced to establish the constitutive model of corroded concrete under cyclic load, and the results calculated by this model matched well with the experimental values. The research in this paper can provide the experimental and theoretical basis for seismic life cycle and fatigue redesign of concrete structures in acid corrosion environments or coastal areas.

STUDY ON TENSILE PROPERTY OF CONCRETE CORRODED BY SODIUM CHLORIDE SOLUTION

Effect of Chloride-Induced Reinforcing Steel Corrosion on the Flexural Strength of Reinforced Concrete Beams

Chloride Transport Behavior in Bending-Shear Section of Reinforced Concrete Beam under Combined Effect of Load and Environment

Chloride Penetration in Surface-Treated Concrete in Natural and Accelerated Environments

Chloride Penetration into Concrete Damaged by Uniaxial Tensile Fatigue Loading

Study on Concrete Deterioration in Different NaCl-Na2SO4 Solutions and the Mechanism of Cl- Diffusion

SIMULATED RESEARCH ON CORROSION OF REINFORCEMENT IN CONCRETE UNDER CHLORIDE ENVIRONMENT

Mechanical Performance of Corroded Steel Bars in Concrete

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

Monotonic and fatigue behavior of steel-concrete composite beams subjected to corrosion

Theoretical and Experimental Investigation of Loading Effects on Chloride Diffusion in Saturated Concrete

Experimental Study on Chloride Ion Transport in Concrete Structure under Shear Stress

Effect of Corrosion on Bond Behavior and Bending Strength of Reinforced Concrete Beams

Degradation Mechanisms of Chloride Contaminated Cast-in-Situ Concrete Partially Exposed to Magnesium-Sulfate Combined Environment

Study on Concrete Deterioration and Chloride Ion Diffusion Mechanism by Different Aqueous NaCl-MgSO4 Concentrations

Shear Performance of Reinforced Concrete Beams with Corroded Stirrups in Chloride Environment

Study on Mechanical Properties and Constitutive Relationship of Concrete Corroded by Hydrochloric Acid under Cyclic Load

EXPERIMENTAL INVESTIGATION AND DESIGN OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Studies on Strength and Flexural Behaviour of Reinforced Concrete Beams with the Corroded Steel Reinforcements as a result of Sodium Chloride (NaCl)

Experimental study on electrical characteristics of ions in concrete at early age under electric field

Test study on bond behavior of corroded steel bars and concrete