Composition dependence of metallic glass plasticity and its prediction from anelastic relaxation - A shear transformation zone analysis

T. J. Lei,L. Rangel DaCosta,M. Liu,J. Shen,Y. H. Sun,W. H. Wang,M. Atzmon
DOI: https://doi.org/10.1016/j.actamat.2020.04.053
IF: 9.4
2020-01-01
Acta Materialia
Abstract:The mechanical relaxation behavior of metallic glasses (MGs) is composition sensitive. For example, in dynamic mechanical analysis, La70Ni15Al15 shows a pronounced secondary peak, termed β relaxation, of the normalized loss modulus at high frequency and/or low temperature, while La70Cu15Al15 only exhibits a shoulder. We have determined relaxation-time spectra at room temperature for these alloys over eleven orders of magnitude of time from quasi-static anelastic relaxation measurements. These are employed to characterize shear transformation zone (STZ) properties in both the α and β regimes. The pronounced β relaxation peak, observed for La70Ni15Al15, is a result of both larger volume fraction of fast and small potential STZs and smaller volume fraction of slow and large potential STZs as compared to La70Cu15Al15. Room-temperature tensile tests show increasing plasticity with decreasing strain rates, characteristic of thermally activated processes. La70Cu15Al15 exhibits greater plasticity than La70Ni15Al15, a negative correlation with the intensity of the β relaxation that is opposite to that previously suggested. The STZ spectra are used to explain the plasticity difference between the two alloys. Plasticity predictions from loss modulus measurements need to be revised, and require absolute measurements.
What problem does this paper attempt to address?