Partial Hydrogenation of Benzene to Cyclohexene over Novel Ru-B/Mof Catalysts

Tan Xiao-He,Zhou Gong-Bing,Dou Rong-Fei,Pei Yan,Fan Kang-Nian,Qiao Ming-Hua,Sun Bin,Zong Bao-Ning
DOI: https://doi.org/10.3866/pku.whxb201403212
2014-01-01
Acta Physico-Chimica Sinica
Abstract:A series of metal-organic framework (MOF) materials were synthesized together with the corresponding amorphous Ru-B/MOF catalysts, which were prepared by the impregnation-chemical reduction method. These materials were subsequently evaluated for the first time as catalysts for the partial hydrogenation of benzene to cyclohexene. The results for the initial hydrogenation rate (r(0)) for the different catalysts followed the trend Ru-B/MIL-53(Al)> Ru-B/MIL-53(Al)-NH2> Ru-B/UIO-66(Zr)> Ru-B/ UIO-66(Zr)-NH2> Ru-B/ MIL-53(Cr)> Ru-B/ MIL-101(Cr)>> Ru-B/ MIL-100(Fe), whereas the initial selectivity for cyclohexene (S-0) was of the order of Ru-B/MIL-53(Al)approximate to Ru-B/MIL-53(Cr)>Ru-B/UIO-66(Zr)-NH2>Ru-B/MIL-101(Cr)>Ru-B/MIL-53(Al)-NH2>Ru-B/UIO-66(Zr)approximate to Ru-B/MIL-100(Fe). The Ru-B/MIL-53(Al) catalyst exhibited the highest r(0) and S-0 values of 23mmol center dot min(-1)center dot g(-1) and 72%, respectively. The characterization results demonstrated that the Ru- B amorphous alloy nanoparticles were highly dispersed on MIL-53(Al) with the average diameter of 3.2 nm. In contrast, the Ru-B nanoparticles on MIL-100(Fe) had an average diameter of 46.6 nm. The smaller Ru-B nanoparticles not only provided more active sites for the hydrogenation to occur, but could also be beneficial in the formation of cyclohexene. The reaction conditions were further optimized for the Ru- B/MIL-53(Al) catalyst. At 180 degrees C under a H2 pressure of 5 MPa, a cyclohexene yield of 24% was obtained, highlighting the potential of MOF materials as catalyst supports for the partial hydrogenation of benzene.
What problem does this paper attempt to address?