Hydrogenated Rutile TiO2 Nanorods and Their Photocatalytic Activity

Cui Hai-Qin,Jing Li-Qiang,Xie Ming-Zheng,Li Zhi-Jun
DOI: https://doi.org/10.3866/pku.whxb201407173
2014-01-01
Abstract:TiO2 rutile nanorods were successfully synthesized by a hydrochloric acid-modified hydrothermal process, using butyl titanate as the titanium source, followed by hydrogenation treatment. The samples were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), UV-Vis near infrared (NIR) diffuse reflection spectroscopy (UV- Vis- NIR DRS), electron paramagnetic resonance (EPR), surface photovoltage spectroscopy (SPS), and the photodegradation of gas-phase acetaldehyde and liquid-phase phenol to evaluate the photocatalytic activity of the catalysts. The results show that the photoresponse of TiO2 gradually expands from the ultraviolet region to the visible and near-infrared regions upon increasing the hydrogenation time at high temperature. Its color changed from white to gray, and this is attributed to the introduction of Ti3+ defects and oxygen vacancies. Based on surface photovoltage spectroscopy responses and the amount of hydroxyl radicals ptoduced, hydrogenation treatment promoted the photogenerated charge separation significantly. This is responsible for the improved photocatalytic degradation activity toward gas-phase acetaldehyde and liquid-phase phenol under visible or ultraviolet irradiation. Therefore, a specific amount of defects and/or vacancies can induce new and appropriate surface states below the conduction band of the TiO2 samples. However, if the amount of introduced defects or vacancies is too high, low-level surface states are produced and this is not favorable for photogenerated charge separation, and detrimental to photocatalytic reactions.
What problem does this paper attempt to address?