Abstract:There are intrinsic phase errors in swept source optical coherence tomography (SS-OCT), which severely influences the functional imaging. To overcome this difficulty, a numerical correction method is presented in this paper to correct the phase artifacts due to wavenumber shift among the spectral interferograms, resulting from the random delay variance between the sampling trigger and the clock of the swept source laser. This correction method is based on the linear relationship of phase difference to the depth of the sample and the wavenumber shift. The detailed procedure to eliminate the phase artifacts is as follows. Firstly, we figure out the complex OCT signals through inverse Fourier transform of the initial interferograms. Then we fit the upper surface of the sample with the intensity information of the B-scan by setting a floating threshold. After that the wavenumber shifts of each A-line are determined by two steps with the phase information of the sample surface: the relative wavenumber shifts between adjacent A-lines are first obtained according to the phase difference between the adjacent A-lines, the signal depth, and the linear relationship mentioned above; then we figure out the absolute wavenumber shifts between each A-line and the first A-line of the B-scan by an iteration algorithm. With the information about the wavenumber shift, we align the initial interferograms, and obtain the corrected complex signal through re-inverse Fourier transform of the aligned interferograms. This method introduces no extra noise, realizing phase measurement limited by the signal-to-noise ratio. It is noted that we take the average phase information of several axial pixels near the sample surface to diminish the noise influence when calculating the wavenumber shifts. Besides, this corrected algorithm acquires oversampling along the scanning direction to ensure the signal correlation between adjacent A-lines. The SS-OCT system in the paper is set up with a vertical cavity surface emitting laser with a center wavelength of 1297 nm. The system measurement range is 12 mm in lateral direction, the axial resolution is 17 mu m, and the lateral resolution is 24 mu m. And the feasibility of this method is verified by Doppler imaging of a mirror, an infra-red detection card and the cerebral cortex of a mouse.

Wavenumber Calibration and Phase Measurement in Swept Source Optical Coherence Tomography

An Absolute Wavenumber Calibration Method Based on Characteristic Spectral Line and Constrained Fitting Phase

Quantitative Phase Imaging Based on Wavefront Correction of a Digital Micromirror Device

Simultaneous wavenumber measurement and coherence detection using temporal phase unwrapping

Comparative analysis of mid-spatial frequency errors measurement using multiple phase retrieval algorithms

Phase correction method based on interfacial signal in swept source optical coherence tomography

Spectral phase based k-domain interpolation for uniform sampling in swept-source optical coherence tomography.

Swept Source Optical Coherence Tomography Based on Non-Uniform Discrete Fourier Transform

Spectral Calibration in Spectral Domain Optical Coherence Tomography

Swept source optical coherence tomography based on scanning fiber probe

Extended Range Phase-Sensitive Swept Source Interferometer for Real-Time Dimensional Metrology

Development of 20 kHz Swept Source Optical Coherence Tomography System

A Method of Fast Locating Discrete Interface Based on Phase Information of Complex Master-Slave Optical Coherence Tomography

Real-time Calibration for High-speed Swept-Source OCT

Recent Developments of Interferometric Wavefront Sensing

Wavenumber calibration and dispersion compensation for Fourier domain optical coherence tomography by parameterized instantaneous frequency estimation method

Full Range Complex Spectral Domain Optical Coherence Tomography Based on Spatial Sinusoidal Phase Modulation

Constrained Polynomial Fit-Based K-Domain Interpolation in Swept-Source Optical Coherence Tomography

Tuning of successively scanned two monolithic Vernier-tuned lasers and selective data sampling in optical comb swept source optical coherence tomography

Efficient Phase Demodulation of Optical Carrier-Based Microwave Interferometry for High-Precision Dynamic Distance Measurement

Systems and Methods for the Spectral Calibration of Swept Source Optical Coherence Tomography Systems