Inverse Emulsion Polymerization of Acrylamide Initiated by Uv Radiation

Ly Liu,Wt Yang
DOI: https://doi.org/10.3321/j.issn:1000-3304.2004.04.015
2004-01-01
Acta Polymerica Sinica
Abstract:A novel method was developed to polymerize acrylamide in an opaque inverse emulsion system by UV light initiation, which was usually used in a transparent system or semi-transparent system, such as solution systems and micro-emulsion systems. Using 2,2-Dimethoxy-2-phenylacetophenone (DMPA) as an initiator, Span80 + OP10 as a blend emulsifier,the inverse emulsion polymerization of acrylamide in kerosene could be completed in about 20 min with exposure under a medium pressure mercury lamp and proper mixing, and the molecular weight of the produced polymer was as high as 10(7). No constant polymerization rate period was observed throughout the whole polymerization process, and there was no dramatic difference between the size of the initial monomer droplets and the size of the final inverse latexes according to scanning electron microscope observation, indicating that the polymerization was nucleated inside the monomer droplets. The influences of the type and concentration of photoinitiator, monomer concentration, emulsifier percentage and reaction temperature on polymerization were investigated. The initiating activity of photoinitiators is in an order of Irgacure 2959 > (ITX + EDAB) > BDK. When the concentration of photoinitiator increases, the reaction rate increases at first, then begins to decrease after the reaction rate reaches a maximum value. Both the reaction rate and the molecular weight increase when the monomer concentration increases. With the increase of the emulsifier percent age the reaction rate increases I while no dramatic change displays in the molecular weight. The overall activation energy of polymerization was measured as 13.34 kJ/mol.
What problem does this paper attempt to address?