Abstract:The present report describes the preparation and characterization of large-bore particle-entrapped monolithic precolumns, which are suitable for incorporation into a two-dimensional liquid chromatography (2D-LC) system for proteome analysis. The fritless precolumns with different inner diameter (i.d.) (320 and 530μm) were rapidly and successfully prepared by entrapping octadecylsilica (ODS) particles (5μm, 300Ǻ) prepacked into fused silica capillaries with a sol–gel network, which was formed by hydrolysis and polycondensation of methyltriethoxysilane (MTES). By optimizing the composition of the sol solution, the resulting large-bore monolithic precolumns of 5mm length allow a flow rate of 20μL/min loading buffer at a reasonable low back pressure of 25bar or less and are capable of withstanding up to 300bar inlet pressure. Scanning electron micrograms of the precolumns profile showed that the evolving sol–gel network joined particles to each other and onto the column wall, and no cracking or shrinkage of the column bed was observed even in 530μm-i.d. capillary. The performance of the particle-entrapped monolithic precolumns used for preconcentration and desalting of proteolytic digest was evaluated by on-line coupling the large-bore precolumns with a capillary reversed-phase liquid chromatographic (RPLC) column followed by UV detection. The laboratory-made monolithic precolumns with 320 and 530μm i.d. were characterized by using BSA tryptic digest or peptide standards as the analytes with respect to sample loading capacity, linearity, recovery and reproducibility, etc. The results indicate that the large-bore and short precolumns (5mm×320μm i.d. or 5mm×530μm i.d.) allow sample fast loading at a flow rate of 30 or 60μL/min. The precolumns also have a mass loading capacity for BSA peptides of about 70μg and for standard peptides of about 80μg. Good linear calibration curves (R2>0.99) were obtained and the limits of detection (signal-to-noise ratio, S/N=3) were improved by more than 60-fold and were between 0.53 and 1.32ng/μL even with a UV absorbance detector. The total recovery was found to be approximately 90–100% for BSA digest and standard peptides. The day-to-day relative standard deviation (RSD) values for recoveries of BSA peptides on a single precolumn ranged from 4.66 to 7.56% and 2.68 to 3.05% for precolumn back pressure, while the column-to-column RSD values were 3.51–6.13% and 1.22–1.26% for recoveries of BSA peptides and precolumn back pressure, respectively. With good precolumn reproducibility, no significant degradation or decrease in precolumn performance was showed even after ∼150 preconcentration/desorption cycles. The precolumns also proved to be resistant to salt buffer with high concentration and low-pH mobile phase. The large-bore particle-entrapped monolithic precolumns will be further used in a high-throughput 2D-LC array system coupled with tandem matrix assisted laser desorption/ionization-time of flight–time of flight–mass spectrometry (MALDI-TOF–TOF–MS) detection for proteome analysis.

PREPARATION OF A BIPOROUS POLYMERIC ADSORBENT FOR RAPID CHROMATOGRAPHIC PURIFICATION OF PLASMID DNA

Preparation of Cellulose Adsorbents with Ionic Liquid and Pore Expansion for Chromatographic Applications

Preparation of Cellulose-Based Chromatography Matrix with Uniform Size by Cross-Flow Microchannel Chip

Preparation of dye-ligand affinity chromatographic packings based on monodisperse poly(glycidylmethacrylate-co-ethylenedimethacrylate) beads and their chromatographic properties.

Preparation of methacrylate-based anion-exchange monolithic microbore column for chromatographic separation of DNA fragments and oligonucleotides

A Novel Polymer-Grafted Hydrophobic Charge-Induction Chromatographic Resin for Enhancing Protein Adsorption Capacity

Preparation of Medium Cation Exchange Stationary Phase of Polymeric Matrix and Their Chromatographic Properties

Preparation and Application of Chiral Monolithic Column for Capillary Liquid Chromatography

Preparation Of New Hydrophilic Monolithic Columns And Their Applications In Capillary Liquid Chromatography And Pressurized Capillary Electrochromatography

Application of Poly(glycidyl Methacrylate-Divinylbenzene-triallylisocyanurate) Monolith in Plasmid Analysis

Surface-initiated Molecularly Imprinted Polymeric Column: in Situ Synthesis and Application for Semi-Preparative Separation by High Performance Liquid Chromatography.

Rapid Separation of Proteins by Capillary HPLC on a Short Polymethacrylate‐based Strong Cation‐exchange Monolithic Column

A novel one‐pot strategy of preparation of N ‐phenylacrylamide‐styrene co‐polymer open tubular capillary column for peptides separation

Preparation of monodisperse porous polymeric ionic liquid microspheres and their application as stationary phases for HPLC

Polystyrene-divinylbenzene-glycidyl methacrylate stationary phase grafted with poly (amidoamine) dendrimers for ion chromatography

Poly(ethylene glycol) functionalization of monolithic poly(divinyl benzene) for improved miniaturized solid phase extraction of protein-rich samples

Large-Bore Particle-Entrapped Monolithic Precolumns Prepared by A Sol-Gel Method for On-Line Peptides Trapping and Preconcentration in Multidimensional Liquid Chromatography System for Proteome Analysis

Preparation of Polymer-Based Amino Acid Stationary Phase and Its Application for Mixed-Mode Chromatography

[Optimization of Preparation of Poly ( Glycidyl Methacrylate-Divinylbenzene) Monolithic Column with Orthogonal Experiments for Separation of Small Molecules].

Surfactant-bound monolithic columns for separation of proteins in capillary high performance liquid chromatography

Fast Preparation And Evaluation Of Cross-Linked And Surface Boned Polyacrylamide Coated Column For Capillary Electrophoresis