Abstract:The anode materials based on conversion or alloying reaction typically show a large specific capacity and suitable working potential in lithium-ion batteries (LIBs). However, the large volume change and relatively low ionic/electronic conductivity lead to poor reversibility and cycle life. In the present work, we report a new lithium–niobium germanate LiNbGeO5 material as the anode material for LIBs in which the in situ formed intermediate LiNbO3 with high ionic/electronic conductivity was introduced during the discharge/charge process. In situ X-ray diffraction and synchrotron-based X-ray absorption near edge spectroscopy proved that conversion and alloying mechanisms were combined. In situ transmission electron microscopy shows a volume change of 30% in the lithiation of carbon-coated LiNbGeO5 (). As a consequence, the anode exhibits a reversible discharge specific capacity of 785 mAh g–1 with a corresponding initial Coulombic efficiency of 76%, and great cycling stability without capacity loss after 5000 cycles at 10 A g–1 (∼75 C). Paired with a LiNi0.5Mn1.5O4 cathode, a full cell was assembled and exhibited a maximum energy density of 368 Wh kg–1 and a power density of 618.7 W kg–1 with an average output voltage of 3.65 V. The work develops a new reaction mechanism for conversion-type materials for LIBs.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acssuschemeng.1c03841.Experimental Section; atomic site information for LiNbGeO5; crystallographic data for LiNbGeO5; initial discharge specific capacity, ICE and volume expansion coefficient of conventional alloying-type and conversion-type anode materials; electrochemical performances of conventional anode materials for LIBs; the XRD patterns of bare LNGO and ; the 1st–3rd discharge/charge curves of uncoated LNGO at 25 mA g–1; the SEM images of GeO2@C; TG curve of carbon-coated GeO2; the cycling performance of and GeO2@C at 200 mA g–1; the first and second charge/discharge curves of LNMO; schematic illustration of the in situ XRD cell; in situ XRD patterns collected during the first discharge/charge of the LNGO electrode; the SEM images of the initial LiNbGeO5@C electrode and the fully discharged LiNbGeO5@C electrode; K-edge XANES spectra of Ge and Nb in LiNbGeO5; schematic illustration of the device for the in situ TEM observation (PDF)This article has not yet been cited by other publications.

GaNb11O29 Nanowebs As High-Performance Anode Materials for Lithium-Ion Batteries

A New Germanium-Based Anode Material with High Stability for Lithium-Ion Batteries

Nb 2 O 5 Nanocrystals Decorated Graphene Composites As Anode Materials for High-Performance Dual-Ion Batteries

Conductive Nb25O62 and Nb12O29 Anode Materials for Use in High-Performance Lithium-Ion Storage

Uniform gallium oxyhydroxide nanorod anodes with superior lithium-ion storage

Electrospinning In0.5Nb24.5O62 nanofibers as a novel anode host with superior lithium storage performance

Nb2O5 nanocrystals decorated graphene composites as anode materials for high-performance dual-ion batteries

Cr0.5Nb24.5O62 Nanowires with High Electronic Conductivity for High-Rate and Long-Life Lithium-Ion Storage

Niobium oxyphosphate nanosheet assembled two-dimensional anode material for enhanced lithium storage

Preparation of Zn3Nb2O8 anode material for high-performance lithium/sodium-ion batteries

W7Nb4O31 Nanorods with a Mixed Crystal Structure: A Very Fast‐ and Stable‐Charging Anode Material for Aqueous Lithium‐Ion Batteries

Crystal Structure Modification Enhanced FeNb11O29 Anodes for Lithium‐Ion Batteries

W6+-doped Nb2O5 as high-rate anode materials for lithium-ion batteries

Amorphous GaN@Cu Freestanding Electrode for High‐Performance Li‐Ion Batteries

Two-Dimensional GaN: An Excellent Electrode Material Providing Fast Ion Diffusion and High Storage Capacity for Li-Ion and Na-Ion Batteries

Na‐Mn‐O Nanocrystals as a High Capacity and Long Life Anode Material for Li‐Ion Batteries

Nanoscale Phase Engineering in Two-Dimensional Niobium Pentoxide Anodes toward Excellent Electrochemical Lithium Storage

Nickel Niobate Anodes for High Rate Lithium‐Ion Batteries

Sodium Niobate with a Large Interlayer Spacing: A Fast-Charging, Long-Life, and Low-Temperature Friendly Lithium-Storage Material

Structure and defect strategy towards high-performance copper niobate as anode for Li-ion batteries

Mn_3O_4 Nanosheet and GNS– Mn_3O_4 Composite as High-Performance Anode Materials for Lithium-Ion Batteries