Abstract:A simple and highly selective flow injection on-line pre-concentration and separation-flame atomic absorption spectrometric method was developed for routine analysis of trace amounts of lead in biological and environmental samples. The selective preconcentration of lead was achieved in a wide range of sample acidity (0.075 to > or = 3 mol L(-1)HNO3) on a microcolumn (145 microL) packed with a macrocycle immobilized on silica gel. The lead retained on the column was effectively eluted with an EDTA solution (0.03 mol L(-1), pH 10.5). Three kinds of potential interferences, i.e., preconcentration inferences from metal ions with an ionic radius similar to that of Pb(II) due to their competition for the cavity of the macrocyle, elution kinetic interferences from ions which form stable complexes with EDTA due to their competition for EDTA, and interferences in the atomizer from residual matrix, were evaluated and compared in view of the read-out mode of the analyte response (peak area vs peak height), column wash step (with vs without), column capacity (50 vs 145 microL), and column shape (conical vs cylindrical). The results showed that a combination of increase in column capacity, quantitation based on peak area, and use of dilute nitric acid for column wash before elution efficiently avoid the above-mentioned potential interferences. With the use of a 145 microL column the present system tolerated up to 0.1 g L(-1) Ba(II), 1 g L(-1) Sr(II), and at least 10 g L(-1) Fe(III), Cu(II), Ni(II), Zn(II), Cd(II), Al(III), K(I), Na(I), CaII), and Mg(II) in the sample digest. Further improvement of the interference tolerance can be achieved by increasing column capacity if more complicated samples need to be analyzed. At a sample loading rate of 3.9 mL min(-1) with 30-s preconcentration, an enrichment factor of 52, a detection limit (3s) of 5 micrograms L(-1) Pb in the digest and a sampling frequency of 63 h(-1) were obtained. The precision (RSD, n = 11) at the 200 micrograms L(-1) level was 1.9%. The enrichment factor and the detection limit can be further improved by increasing sample loading rate without degradation in the efficiency due to the favorable kinetics and low hydrodynamic impedance of the present system. The analytical results obtained by the proposed method for a number of biological and environmental standard reference materials were in good agreement with the certified and recommended values.

In Situ Preconcentration of Lead by Dielectric Barrier Discharge and Its Application to High Sensitivity Surface Water Analysis.

Fast and High Sensitive Analysis of Lead in Human Blood by Direct Sampling Hydride Generation Coupled with in Situ Dielectric Barrier Discharge Trap

Quantification of ultra-trace organolead species in environmental water by inductively coupled plasma mass spectrometry with online solid-phase extraction and high performance liquid chromatographic separation

Simultaneous Enrichment of Inorganic and Organic Species of Lead and Mercury in Pg L−1 Levels by Solid Phase Extraction Online Combined with High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

Air mixing sorption flow injection preconcentration in a knotted reactor coupled with flame atomic absorption spectrometry for determination of trace lead in water

Application of a macrocycle immobilized silica gel sorbent to flow injection on-line microcolumn preconcentration and separation coupled with flame atomic absorption spectrometry for interference-free determination of trace lead in biological and environmental samples

Room-temperature Chelate Vapor Generation of Lead Using Ammonium Ο,Ο-Diethyl Dithiophosphate As a Chelating Reagent and Determination by Atomic Fluorescence Spectrometry in Environmental Water Samples

Simultaneous determination of noble metals (Rh, Pd, Ir, Pt, and Au) in environmental samples by nebulized film dielectric barrier discharge vapor generation coupled with inductively coupled plasma mass spectrometry

Determination of lead in complex sample matrices by atomic fluorescence spectrometry: optimisation of online hydride generation

Hollow-fiber Liquid-Phase Microextraction Prior to Low-Temperature Electrothermal Vaporization ICP-MS for Trace Element Analysis in Environmental and Biological Samples.

In Situ Monitoring of Pb2+ Leaching from the Galvanic Joint Surface in a Prepared Chlorinated Drinking Water.

Dispersive Liquid-Liquid Microextraction Using Low-Toxic Solvent for the Determination of Heavy Metals in Water Samples by Inductively Coupled Plasma-Mass Spectrometry.

Quantitative Analysis of Lead in Aqueous Solutions by Ultrasonic Nebulizer Assisted Laser Induced Breakdown Spectroscopy

High Sensitivity Determination of Antimony with Application for the Characterization of Its Migration in Bottled Water by a Dielectric Barrier Discharge (DBD) Coupled with Hydride Generation – Atomic Fluorescence Spectrometry (HG-AFS)

Photochemical vapor generation of lead for inductively coupled plasma mass spectrometric detection

Selective Solid-Phase Extraction of Lead(Ii) from Biological and Natural Water Samples Using Surface-Grafted Lead(Ii)-Imprinted Polymers

Headspace Solid-Phase Microextraction Coupled to Miniaturized Microplasma Optical Emission Spectrometry for Detection of Mercury and Lead.

Novel Dielectric Barrier Discharge Trap for Arsenic Introduced by Electrothermal Vaporization: Possible Mechanism and Its Application

In Situ Dielectric Barrier Discharge Trap for Ultrasensitive Arsenic Determination by Atomic Fluorescence Spectrometry

A Portable Microplasma Optical Emission Spectrometric Device with Online Digestion Function for Field and Sensitive Determination of Lead in Biological Samples.