Abstract:High internal phase emulsions (HIPEs), also called highly concentrated emulsions with a minimal internal phase volume fraction of 74%, have been paid increasing attention in the development of functional foods due to their high potential in loading with large amounts of hydrophobic nutriceuticals. In the present study, HIPEs stabilized by polyphenol-amyloid supramolecular filaments were prepared for encapsulation of olive oil and loading with lutein. Binding and stacking of the green tea polyphenol epigallocatechin gallate (EGCG) on the surface of amyloid fibrils fabricated from hen egg lysozyme resulted in the hybrid supramolecules, which assembled to form hydrogels. The amyloid fibril clusters shrouded by EGCG were observed in the microstructure of the hydrogels characterized by atomic force microscopy (AFM). HIPEs stabilized by the EGCG-amyloid fibril supramolecules showed the typical microstructure of highly packed polyhedral geometric oil droplets. The gel strength of the HIPEs stabilized by the hybrid supramolecules was greater than that of HIPEs stabilized by pure amyloid fibrils. The droplet size of the HIPEs first decreased and then increased with the increase of EGCG contents in the hybrid supramolecules, which was consistent with the corresponding emulsion morphologies obtained from the images of confocal laser scanning microscopy (CLSM). Aggregation of the protein-based nanofibrils appeared in the continuous phase at higher EGCG contents. The droplet size of the HIPEs decreased with the increase of the amyloid fibril concentration, accompanied by more packed and homogenously dispersed lipid droplets, as shown in the CLSM images. A high loading content of lutein of up to 10 mg/mL in the prepared HIPEs was realized, and the stability of lutein against ultraviolet irradiation, heat, iron, and hydrogen peroxide was promoted significantly. In addition, encapsulation with the HIPEs prevented the oxidization of olive oil, and this effect was enhanced with the increase of the EGCG content in the hybrid supramolecules ranging from 0 to 0.25 wt %. The protection function of the HIPEs might be ascribed to the membrane of interfacial amyloid fibrils and the crowded oil droplet environment, both of which could shield the pro-oxidation factors.

Synergistic enhancement of loading contents and chemical stability of lycopene distributing both inside and on the oil/water interface

Optimization of Formulation and Influence of Environmental Stresses on Stability of Lycopene-Microemulsion

Tailoring the Properties of Double-Crosslinked Emulsion Gels Using Structural Design Principles: Physical Characteristics, Stability, and Delivery of Lycopene.

Stability and digestibility of encapsulated lycopene in different emulsion systems stabilized by acid-modified soybean lipophilic protein

Thermal-induced-stable High Internal Phase Emulsion for Lycopene Encapsulation and Delivery: Pre-heat Treatment Mediated Facilitation on the Isomerization, Stabilization, and Release of Lycopene

Fabrication and characterization of Pickering High Internal Phase Emulsions (HIPEs) stabilized by chitosan-caseinophosphopeptides nanocomplexes as oral delivery vehicles

High Loading Contents, Distribution and Stability of Β-Carotene Encapsulated in High Internal Phase Emulsions

High Internal Phase Emulsions Stabilized with Polyphenol-Amyloid Fibril Supramolecules for Encapsulation and Protection of Lutein

Lycopene-loaded Bilayer Emulsions Stabilized by Whey Protein Isolate and Chitosan

Lycopene Nanoparticles Coated with Microemulsions to Improve Stability

Development of Antioxidant Pickering High Internal Phase Emulsions (hipes) Stabilized by Protein/polysaccharide Hybrid Particles As Potential Alternative for PHOs.

Utilization of Polysaccharide-Based High Internal Phase Emulsion for Nutraceutical Encapsulation: Enhancement of Carotenoid Loading Capacity and Stability

Improved Stability and Controlled Release of Lycopene Via Self-Assembled Nanomicelles Encapsulation

High Internal Phase Pickering Emulsions Stabilized by Zein/whey Protein Nanofibril Complexes: Preparation and Lycopene Loading

Enhancing Lycopene Stability and Bioaccessibility in Homogenized Tomato Pulp Using Emulsion Design Principles

Lycopene-loaded emulsions stabilized by whey protein covalently modified with pectin or/and chlorogenic acid: Enhanced physicochemical stability and reduced bio-accessibility.

Encapsulation of Lycopene Within Oil-in-water Nanoemulsions Using Lactoferrin: Impact of Carrier Oils on Physicochemical Stability and Bioaccessibility

Outstanding antioxidant pickering high internal phase emulsions by co-assembled polyphenol-soy -conglycinin nanoparticles

Encapsulation of lycopene in Pickering emulsion stabilized by complexes of whey protein isolate fibrils and sodium alginate: Physicochemical property, structural characterization and in vitro digestion property

Fabrication of Ultrastable Water-in-oil High Internal Phase Emulsion As Versatile Delivery Vehicle Through Synergetic Stabilization

High internal phase emulsions stabilized with carboxymethylated lignin for encapsulation and protection of environmental sensitive natural extract