Abstract:Cu nanoparticle/graphene oxide/single walled carbon nanotube (CuNP/GO/SWCNT) composites were prepared by a facile electrodeposition method and used for constructing nonenzymatic glucose sensor. Scanning electron microscopy (SEM) and Raman spectroscopy were employed to characterize the morphology and structures of the samples. The electrocatalytic performance of CuNP/GO/SWCNT composites towards glucose oxidation was studied by cyclic voltammetry (CV) and current–time measurements. Electrochemical results indicated that CuNP/GO/SWCNT electrode exhibited a higher electrocatalytic activity towards the oxidation of glucose than CuNP, CuNP/GO and CuNP/SWCNT electrodes. This was because the GO/SWCNT composite as substrate material not only possessed excellent conductivity, but also provided large surface area for the high loading of the CuNPs. Meanwhile, the good dispersibility, independent and multi-layer structure of CuNP, could enhance the charge-transport properties, and afford more active sites for the catalytic oxidation of glucose. Under the optimized conditions, the sensor showed a high sensitivity of up to 930.07μAmM−1cm−2, with a wide linear range of 1μM to 4.538mM and a low detection limit of 0.34μM (S/N=3). It also exhibited excellent stability, reproducibility, selectivity, and reliable measurement in real human blood samples. All of these excellent properties made the CuNP/GO/SWCNT composite material promising for the development of effective nonenzymatic glucose sensors.

One-step Hydrothermal Synthesis of Cu2O/CuO Hollow Microspheres/reduced Graphene Oxide Hybrid with Enhanced Sensitivity for Non-Enzymatic Glucose Sensing

Free-standing hybrid material of Cu/Cu2O/CuO modified by graphene with commercial Cu foil using for non-enzymatic glucose detection

Free-standing hybrid material of Cu/Cu<sub>2</sub>O/CuO modified by graphene with commercial Cu foil using for non-enzymatic glucose detection

Facile synthesis of uniform CuO/Cu2O composite hollow microspheres for a non-enzymatic glucose sensor

Synthesis of Cu2O on AlOOH/reduced graphene oxide for non-enzymatic amperometric glucose sensing

RGO@Cu2O@Cu Ternary Nanocomposite for High-Performance Non-Enzymatic Glucose Detection

Synthesis of graphene oxide based CuO nanoparticles composite electrode for highly enhanced nonenzymatic glucose detection.

Design and Fabrication of Ag-CuO Nanoparticles on Reduced Graphene Oxide for Nonenzymatic Detection of Glucose

Synthesis of Hollow Nanospherical Cuprous Oxide Supported by Nitrogen-Doped Reduced Graphene Oxide and Its Application to Enzyme-Free Glucose Sensing

Copper Nanoparticle/Graphene Oxide/Single Wall Carbon Nanotube Hybrid Materials As Electrochemical Sensing Platform for Nonenzymatic Glucose Detection

RGO@Cu 2 O@Cu Ternary Nanocomposite for High-Performance Non-Enzymatic Glucose Detection

Self-Assembly of Graphene-Encapsulated Cu Composites for Nonenzymatic Glucose Sensing

One-step hydrothermal synthesis of CuS/MoS2 composite for use as an electrochemical non-enzymatic glucose sensor

A Facile Synthesis of CoMn2O4 Nanosheets on Reduced Graphene Oxide for Non-Enzymatic Glucose Sensing.

Electrochemical biosensor based on copper sulfide/reduced graphene oxide/glucose oxidase construct for glucose detection

Facile Growth of Cu2o Nanowires on Reduced Graphene Sheets with High Nonenzymatic Electrocatalytic Activity Toward Glucose

Non-enzymatic Glucose Biosensor Based on Copper Oxide-Reduced Graphene Oxide Nanocomposites Synthesized from Water-Isopropanol Solution

Non-enzymatic Amperometric Glucose Sensor Based on Copper Nanowires Decorated Reduced Graphene Oxide

CuO nanoparticles on sulfur-doped graphene for nonenzymatic glucose sensing

Ultrasensitive Non-Enzymatic Glucose Sensors Based on Hybrid Reduced Graphene Oxide and Carbonized Silk Fabric Electrodes Decorated with Cu Nanoflowers

Facile Synthesis of Layered CuS/RGO/CuS Nanocomposite on Cu Foam for Ultrasensitive Nonenzymatic Detection of Glucose