Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

A prediction and damage assessment model for snowmelt flood events in middle and high latitudes Region

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

Visualization and Damage Assessment for Flooded Area

Early-warning and Prediction of Highway Flood Damage Based on Rainfall Rating Index Method

A Mathematical Model For Flood Loss Estimation Based On Spatial Grid

Flood Area and Damage Estimation in Zhejiang, China

A Mathematical Model for Flood Loss Estimation Based on Grid

Modelling and validation of flash flood inundation in drylands

A GIS Based Model for Calculating of Flood Area

Sub-Daily Simulation of Mountain Flood Processes Based on the Modified Soil Water Assessment Tool (SWAT) Model

Exploration of Flood Prediction in Watersheds Based on the Fusion Analysis of Remote Sensing Big Data with Multiple Physical Fields

Altitude characteristics in the response of rain-on-snow flood risk to future climate change in a high-latitude water tower

Spring Flood Forecasting Based on the WRF-TSRM Mode

A Review on Snowmelt Models: Progress and Prospect

Based on the improved SCGM(1,1)c and WIV rainfall landslide susceptible area prediction model

Forecasting And Providing Warnings Of Flash Floods For Ungauged Mountainous Areas Based On A Distributed Hydrological Model

A Rapid Prediction Model of Urban Flood Inundation in a High-Risk Area Coupling Machine Learning and Numerical Simulation Approaches

REMOTE SENSING BASED SNOWMELT RUNOFF MODEL COUPLED WITH DISTRIBUTED HYDROLOGICAL MODEL IN UPPER YELLOW RIVER BASIN

A Dynamic Early Warning Model for Flash Floods Based on Rainfall Pattern Identification

A mathematical model to improve water storage of glacial lakes prediction towards addressing glacial lake outburst floods

From China’s Heavy Precipitation in 2020 to a “Glocal” Hydrometeorological Solution for Flood Risk Prediction