Abstract:The importance of the geological model in a geotechnical engineering project has long been recognized. However, the uncertainty associated with the geological model has rarely been quantified and explicitly considered in the geotechnical design. This paper explores the role of the geological model uncertainty and the benefit of reducing such uncertainty in a geotechnical design. To this end, the landslide that occurred on 25 April 2010 at 3.3 K of Freeway No. 3 in Northern Taiwan, referred to herein as NH-3 Slope, is re-analyzed with an assumed geological model (a dip-slope model in this case) under various uncertainty scenarios. Traditionally, the design (i.e., a choice of design parameters such as slope height, slope angle, and supporting anchors) of a rock slope seeks to satisfy a target factor of safety (FS). In the case of NH-3 Slope, the apparent dip angle of the slip surface along the dip direction of slope constitutes the geological model of concern. Different survey techniques produce data with varying degrees of error (or uncertainty) in the measured apparent dip angle. For example, data from a Regional Geological Map (RGM) typically yields an estimate of the bedding plane attitude with a significant level of uncertainty due primarily to low data density. In contrast, LiDAR can significantly reduce the uncertainty of the derived bedding plane attitudes. By lowering this uncertainty, the variation (or uncertainty) in the computed FS may be reduced, which tends to yield a lower failure probability (Pf), given other conditions being the same. The benefit of lowering the geological model uncertainty in a geotechnical design is demonstrated through a retrospective analysis of the NH-3 Slope.

Jackknifing for modeling sampling properties of soil statistics for geotechnical reliability analysis

Weighted Low-Discrepancy Samplings: A Novel Method for Slope System Reliability Analysis

Efficient Reliability Analysis of Slopes Integrating the Random Field Method and a Gaussian Process Regression‐based Surrogate Model

Probabilistic Evaluation of Ground-Support Interaction for Deep Rock Excavation Using Artificial Neural Network and Uniform Design

Fuzzy Random Reliability Analysis of Blocky Rock-Mass in Slopes

Reliability Analysis of Deep Excavation Based on Field Monitoring Data

Implementing statistical fitting and reliability analysis for geotechnical engineering problems in R

Jackknife empirical likelihood confidence intervals for assessing heterogeneity in meta-analysis of rare binary event data

Construction of Adaptive Kriging Metamodel for Failure Probability Estimation Considering the Uncertainties of Distribution Parameters

Reliability analysis with scarce information: Comparing alternative approaches in a geotechnical engineering context

Probabilistic Assessment of Seismic Stability of a Rock Slope by Combining the Simulation of Stochastic Ground Motion with Permanent Displacement Analysis

The role of the geological uncertainty in a geotechnical design – A retrospective view of Freeway No. 3 Landslide in Northern Taiwan

Improved Probabilistic Kinematic Analysis Procedure Based On Finite Size Discontinuities And Its Application To A Rock Slope At Open Pit Mine In Us

Efficient Bayesian characterization of cohesion and friction angle of soil using parametric bootstrap method

Subsampling and Jackknifing: A Practically Convenient Solution for Large Data Analysis with Limited Computational Resources

A Kriging-assisted sampling method for reliability analysis of structures with hybrid uncertainties

Geotechnical uncertainty, modeling, and decision making

A Bayesian bootstrap-Copula coupled method for slope reliability analysis considering bivariate distribution of shear strength parameters

Reliability analysis and risk assessment of pile-reinforced slopes considering spatial soil variability and site investigation

Jackknife empirical likelihood with complex surveys

Discriminative Jackknife: Quantifying Uncertainty in Deep Learning via Higher-Order Influence Functions