Abstract:Abstract. Mobile differential optical absorption spectroscopy (mobile DOAS) has become an important tool for the quantification of emission sources, including point sources (e.g., individual power plants) and area emitters (e.g., entire cities). In this study, we focused on the error budget of mobile DOAS measurements from point sources, and we also offered recommendations for the optimum settings of such measurements. First we established a Gaussian plume model from which the NOx and SO2 distribution from the point source was determined. In a second step the simulated distributions are converted into vertical column densities of NOx and SO2 according to the mobile DOAS measurement technique. With assumed parameters, we then drove the forward model in order to simulate the emissions, after which we performed the analysis. Following this analysis, we conclude that: (1) Larger sampling resolution clearly results in larger flux error. The proper resolution we suggest is between 5 m and 50 m. Even larger resolutions may also be viable, but > 100 m is not recommended. (2) Error effects vary with measurement distance from the source. We found that undetectable flux (measured VCDs are under the detection limit) is the main error source when measuring far from the source, for both NOx and SO2. When measuring close to the source, low sampling frequency results in large flux error. (3) The wind field primarily affects 2 aspects of the flux measurement error. When measuring far from the source, dispersion results in more undetectable flux, which is the main error source. When measuring close to the source, wind field uncertainty becomes the main error source of SO2 flux, but not of NOx. We suggested that the proper wind speed for mobile DOAS measurements is between 1 m/s and 4 m/s. (4) The study of NOx atmospheric chemistry reactions indicated that a [NOx]/[NO2] ratio correction has to be applied when measuring very close to the emission source. But even when such a correction is applied, the remaining errors can be significant. To minimize the [NOx]/[NO2] ratio correction error, we recommended 0.05 NO2 maximum reaction rate as the accepted NOx steady-state thus to determine the proper starting measurement distance. (5) The error of the spectral retrieval is not a main emission flux error source and its error budget varies with the measuring distance. (6) Increasing the number of measurements can lower the flux error that results from wind field uncertainty and retrieval error. This directly indicates that SO2 flux error could be lowered if the measurements are repeated when not too far from the emission source. With regard to NOx, more measurement times can only work effectively when not very close or too far from the source. (7) Also the effects of the temporal and spatial sampling are investigated. When the sampling resolution is prescribed, the integration depends on the driving speed and the corresponding flux error is mainly determined by the undetectable flux. When the car speed is prescribed, the integration time is determined by the sampling resolution for measuring near the source, while undetectable flux predominates when far away. (8) As a general recommendation, our study suggests that emission rates < 30 g/s for NOx and < 50 g/s for SO2 are not recommended for mobile DOAS measurements. The source height affects the undetectable flux, but has little influences on the total error. Based on the model simulations our study indicates that mobile DOAS measurements are very well suited tool to quantify point source emissions. The results of our sensitivity studies are important to make optimum use of such measurements.

Evaluation of Backward Lagrangian Stochastic (bls) Model to Estimate Gas Emissions from Complex Sources Based on Numerical Simulations

Lagrangian stochastic simulation of atmospheric dispersion from sources near the ground

Evaluation of Backward and Forward Lagrangian Footprint Models in the Surface Layer

An inverse Gaussian plume approach for estimating atmospheric pollutant emissions from multiple point sources

Research on Traceability Method of Gas Leak for Emergency Auxiliary Support

Gas Diffusion Model Based on an Improved Gaussian Plume Model for Inverse Calculations of the Source Strength

Inverse calculation of vessel emission source intensity based on optimized Gaussian puff model and particle swarm optimization algorithm

Evaluation of Simulated CO2 Point Source Plumes from High-Resolution Atmospheric Transport Model

Airborne contaminant source estimation using a finite-volume forward solver coupled with a Bayesian inversion approach

A New Approach to Estimate Pollutant Emissions Based on Trajectory Modeling and Its Application in the North China Plain

Pollution Gas Concentration and Diffusion Model in Shale Gas Flowback Fluid

The quantification of NOx and SO2 point source emission flux errors of mobile DOAS on the basis of the Gaussian dispersion model: A simulation study

Contaminant Dispersion Prediction and Source Estimation with Integrated Gaussian-machine Learning Network Model for Point Source Emission in Atmosphere.

High spatial and temporal resolution simulations of methane column loadings due to routine emissions and emission events in oil and gas regions

The quantification of NO&lt;sub&gt;&lt;i&gt;x&lt;/i&gt;&lt;/sub&gt; and SO&lt;sub&gt;2&lt;/sub&gt; point source emission flux errors of mobile DOAS on the basis of the Gaussian dispersion model: A simulation study

Locating the Gas Leakage Source in the Atmosphere Using the Dispersion Wave Method

Probabilistic Inversion Modeling of Gas Emissions: A Gradient-Based MCMC Estimation of Gaussian Plume Parameters

Estimates of Methane Emissions in Beijing Using a Backward Trajectory Inversion Model

Emission Rate Estimation of Industrial Air Pollutant Emissions Based on Mobile Observation

Influence of Different Fitting Models on Gas Fluxes Estimation Across Water-air Interfaces with Static Floating Chamber

An inversion method for estimating strong point carbon dioxide emissions using a differential absorption Lidar