Abstract:Passive dynamic walkers can steadily walk down gentle slope under only action of gravity without any drivers and controls,and they have human-like characteristic of walk and high energy efficiency.The study on them has a key role in designing robots and medical prosthetics.Hence,it has attracted considerable public concern in recent years. The contact configuration of the biped walkers also varies correspondingly due to the transitions between feet and ground from slip to stick or from contact to detachment.For the non-smooth and nonlinear model with variable structure,it is generally to simply regard the model as an inverted pendulum fixed at each foot in turn by means of McGeer＇ Step-to-Step method.Here are the basic assumptions of the traditional method （Step-to-Step method）：There is no slip between feet and ground,and plastic collision occurs at heelstrick while conserving angular momentum.In addition,it is assumed that stance leg and swing leg change instantaneously and no impulse acts on the swing foot.Although the traditional method is widely employed,the shortcomings of the method can not be neglected as follows：Firstly,slip phenomenon can not be dealt with;secondly,no direct simulation or experiment results support the assumption of angular momentum conservation of passive dynamic walker about heelstrike;thirdly,it is not suitable for analyzing general movements of the biped walker. Planar straight-legged passive dynamic walker with round foot can be considered as a multibody system with unilateral constrains.Based on differential inclusions and complementary methods,the theory of nonsmooth multibody dynamics with unilateral constraints has been well established,by which the multi-contact problems with friction and impact could be efficiently solved.In this paper,this passive walking phenomenon is simulated by using the non-smooth dynamic method.We mainly analyze the Coulomb friction and Newton impact phenomenon between feet and ground.Due to the collisions,the whole dynamical equation and contact laws are set up on base of impulse-velocity level.After establishing the complementary relationships of all contact laws,a linear complementary problem in standard form is given.And then,we choose a one-step midpoint time-stepping method for numerical simulation.The programming with the non-smooth method is easier than that of the traditional method. The following conclusions are obtained from numerical simulations in this paper：（1）If there is no slip and the collisions are plastic,the simulation results agree with those of the traditional methods,which indicate that the assumptions of the Step-to-Step method are reasonable.（2）In the case of slip and plastic impact,stable periodic gaits could also be found with some suitable parameters.For this case,the friction coefficient has a significant effect on the average walking velocity in tangential direction.（3）If elastic impact occurs without slipping,passive dynamic walkers could also steadily walk down slopes with several collisions at the transition from swing leg to stance leg.Small normal coefficient of restitution has little effect on average walking speed. （4）The simulation results show that for a small normal coefficient of restitution and a large friction coefficient, it is easy for passive dynamic walkers to realize stable periodic gaits.

A damped bipedal inverted pendulum for human-structure interaction analysis

Investigation of 3D Bipedal Spring-Loaded Inverted Pendulum Human Walking Model on Laterally Vibrating Surfaces in the Case of Phase Drift, Phase Pulling, and Synchronization

Push Recovery for Humanoid Robots with Passive Damped Ankles

Development of a Novel Elastic Load-Carrying Device: Design, Modeling and Analysis

Tip over Avoidance Control for Biped Robot

A spring-loaded inverted pendulum model for analysis of human-structure interaction on vibrating surfaces

Calculation method for human-bridge vertically coupled vibration

An inverted pendulum model based humanoid gait generation using convex optimization

Stable walking control and strategy of under-actuated biped robot

Stability Analysis of a Pedestrian’s Walking Motion Based on the Inverted Pendulum Model

An Inverted Pendulum Model Describing the Lateral Pedestrian-Footbridge Interaction

Passive walking biped robot model with flexible viscoelastic legs

Gait Optimization and Energy-Based Stability for Biped Locomotion Using Large-Scale Programming

Biped Walking Based on Stiffness Optimization and Hierarchical Quadratic Programming

Human-structure dynamic interactions: Identification of two-degrees-of-freedom walking human model

Stability analysis and control of the jumping interaction in self-paced treadmills

The Condition of Dynamic Stability for Self-Paced Treadmill Walking Based on Inverted Pendulum Model

Modeling and experimental study on walking human-structure interaction systems subjected to earthquake excitations

Delay-induced Hopf bifurcation in the double-link inverted pendulum system for human quiet standing

SIMULATION RESEARCH OF A PASSIVE DYNAMIC WALKER WITH ROUND FEET BASED ON NON-SMOOTH METHOD

On the analysis and control of a bipedal legged locomotion model via partial feedback linearization