Abstract:Liquefied petroleum gas (LPG) is known as clean fuel and its importance will be continued in the future. However, most of LPG is currently produced from fossil resources. Thus, producing LPG from CO 2 as a renewable source is significant for achieving carbon neutrality. One possible way to produce LPG from CO 2 is through an indirect pathway via methanol/dimethyl ether and propylene/butene. The final step of this pathway is the hydrogenation reaction of olefins to produce paraffins. Although H 2 O may coexist in this reaction, there have been few studies to investigate reaction kinetics of propylene hydrogenation in the presence of H 2 O. Here, we measured the propylene conversion over different four catalysts: Pt/α-Al 2 O 3 , Pd/α-Al 2 O 3 , Pt/ZrO 2 , and Pd/ZrO 2 . We varied a reaction temperature and concentrations of propylene, H 2 and H 2 O in the feed. We found that above 200 °C the propylene conversion was negatively affected by the reaction temperature and the propylene concentration, while it was positively affected by the H 2 concentration. We also found that the dependence of propylene conversion on H 2 O concentration depended on the catalysts. To reproduce the measured results, a kinetic model based on the Langmuir-Hinshelwood mechanism was developed over Pt/ZrO 2 which showed the best reaction performance among the catalysts used. A two-dimensional reactor model consisting of mass and heat balance equations was developed for exploring the desirable reactor type. The simulations showed that the externally cooled reactor with a catalyst density gradient was the most suitable for propylene hydrogenation in terms of heat management and propylene conversion.

Conversion of the off Gas from Polypropylene Process

Direct Conversion of Methane to Propylene

Comprehensive Pore Tuning in an Ultrastable Fluorinated Anion Cross‐Linked Cage‐Like MOF for Simultaneous Benchmark Propyne Recovery and Propylene Purification

Pyrolysis of Polyolefins Using Rotating Arc Plasma Technology for Production of Acetylene

Gas Production from Polyethylene Terephthalate Using Rotating Arc Plasma

Modulating Pore Microenvironment in a Robust Ionic Porous Polymer for Efficient Propyne/propylene Separation

Process optimization, exergy efficiency, and life cycle energy consumption-GHG emissions of the propane-to-propylene with/without hydrogen production process

High Conversion Propane Dehydrogenation by Photocatalysis under Ambient Conditions

Catalytic Conversion of Polyethylene and Polypropylene Wastes to Light Olefins

Efficient conversion of propane in a microchannel reactor at ambient conditions

CONVERSION OF WASTE POLYPROPILENE (PP) USING THE ZEOLITE Ni/ZSM-5 TO LIQUID FUEL

Study of Propane Dehydrogenation to Propylene in an Integrated Fluidized Bed Reactor Using Pt-Sn/Al-SAPO-34 Novel Catalyst

Propylene hydrogenation on pt/α-Al2O3, pd/α-Al2O3, pt/ZrO2, and pd/ZrO2 in the presence of H2O: experimental and modeling study

Carbon dioxide utilization in propylene carbonate production process

Research Progress on Propylene Preparation by Propane Dehydrogenation

Energy-Efficient Coaromatization of Methane and Propane

Efficient Separation of Propylene from Propane in an Ultramicroporous Cyanide‐Based Compound with Open Metal Sites

Recovering Valuable Chemicals from Polypropylene Waste via a Mild Catalyst-Free Hydrothermal Process

Modeling and steady state multiplicity analysis of gas phase polypropylene horizontal stirred bed reactor

THERMODYNAMIC ANALYSIS OF PROPYLENE-ENHANCING FCC PROCESS

Characterizations of the gaseous fractions by catalytic copyrolysis of biomass and polypropylene