Abstract:This paper proposes a finite‐time command filtered control strategy to address both the tracking control and the synchronization control problems. The lumped disturbances are observed by extended state observers, and the finite‐time control approach achieves fast response and high precision. A dual‐motor servo mechanism is a high‐order and strong‐coupling system with unknown nonlinearity, which brings challenges to controller design to realize high‐performance tracking and synchronization. This article proposes a finite‐time command filtered control strategy to address this problem. In tracking control design, finite‐time command filters are adopted to obtain the derivatives of virtual controllers, and the "explosion of complexity" problem in backstepping is thus solved. An improved compensation system is designed to reduce filtering errors. The tracking control is developed based on the combination of finite‐time control and command filtered approach. Moreover, to deal with unknown nonlinearities and uncertainties, fast finite‐time extended state observers are developed to observe lumped disturbances for the load and motor, respectively. In synchronization control design, two opposite control actions are developed using the speed difference to force two motors to rotate synchronously. The finite‐time convergence of the tracking and synchronization errors is proved. The efficiency of the proposed control strategy is verified via experiments conducted on a dual‐motor servo turntable.

Method of the 2 Nd Differential Angular Acceleration Observer Based on Series Position Linear-Fitting Differential Filters

A Fast Integral Sliding Mode Controller with an Extended State Observer for Position Control of Permanent Magnet Synchronous Motor Servo Systems

High Acceleration Motion Control Based on a Time-Domain Identification Method and the Disturbance Observer

Low speed servo system with second-order sliding mode algorithm

Adaptive type-2 fuzzy output feedback control using nonlinear observers for permanent magnet synchronous motor servo systems

A Joint Acceleration Estimation Method Based on a High-Order Disturbance Observer.

Researches on Time-Domain Relay Feedback Identification Approaches for High-Acceleration Linear Servo Systems

Angular Acceleration Observer Design for Jerk-level Control of Tiltrotors Based on the High-order Fully Actuated System Approaches

Multi-Axis Servo System Control Design Considering Low-Speed Friction Dynamics

Control of Planar Motor on the Basis of the Adaptive Feedforward

Design of sliding mode controller for servo feed system based on generalized extended state observer with reinforcement learning

Two Time-Scale Observer-Based Robust Motion Controller Design and Realization of a Linear Actuator.

A Modified Disturbance Observer Structure Based on Acceleration Measurement for Disturbance Suppression in Tracking Control System

Low Speed Control of PMAC Servo System Based on Reduced-order Observer

Enhanced command filtered control with extended state observer for dual‐motor servo mechanisms considering backlash and friction

Mechanical Resonance Suppression and Disturbance Rejection of Two-Mass System Based on State-Feedback Observer

Discrete Second-Order Sliding Mode Adaptive Controller Based on Characteristic Model for Servo Systems

A Method of Speed Observation Based on Least-Squares Linear-Fitting with Weight Factor

A New Load Adaptive Identification Method Based on an Improved Sliding Mode Observer for PMSM Position Servo System

Adaptive Observer Design for Wide-Speed Sensorless IPMSM Drives Via Equivalent Control Method

Frication Compensation and Disturbance Observer Design for a High Acceleration Precision Direct Drive Motion Stage