Abstract:Abstract. A source-oriented representation of airborne particulate matter was added to the Weather Research & Forecasting (WRF) model with chemistry (WRF/Chem). The source-oriented aerosol separately tracks primary particles with different hygroscopic properties rather than instantaneously combining them into an internal mixture. The source-oriented approach avoids artificially mixing light absorbing black + brown carbon particles with materials such as sulfate that would encourage the formation of additional coatings. Source-oriented particles undergo coagulation and gas-particle conversion, but these processes are considered in a dynamic framework that realistically "ages" primary particles over hours and days in the atmosphere. The source-oriented WRF/Chem model more accurately predicts radiative feedbacks from anthropogenic aerosols compared to models that make internal mixing or other artificial mixing assumptions. A three-week stagnation episode (15 December 2000 to 6 January 2001) during the California Regional PM10/PM2.5 Air Quality Study (CRPAQS) was chosen for the initial application of the new modeling system. Emissions were obtained from the California Air Resources Board. Gas-phase reactions were modeled with the SAPRC90 photochemical mechanism. Gas-particle conversion was modeled as a dynamic process with semi-volatile vapor pressures at the particle surface calculated using ISORROPIA. Source oriented calculations were performed for 8 particle size fractions ranging from 0.01–10 μm particle diameters with a spatial resolution of 4 km and hourly time resolution. Primary particles emitted from diesel engines, wood smoke, high sulfur fuel combustion, food cooking, and other anthropogenic sources were tracked separately throughout the simulation as they aged in the atmosphere. Results show that the source-oriented representation of particles with meteorological feedbacks in WRF/Chem changes the aerosol extinction coefficients, downward shortwave flux, and primary and secondary particulate matter concentrations relative to the internally mixed version of the model. Downward shortwave radiation predicted by source-oriented model is enhanced by 1% at ground level chiefly because diesel engine particles in the source-oriented mixture are not artificially coated with material that increases their absorption efficiency. The extinction coefficient predicted by the source-oriented WRF/Chem model is reduced by an average of ∼ 5–10% in the central valley with a maximum reduction of ∼ 20%. Particulate matter concentrations predicted by the source-oriented WRF/Chem model are ∼ 5–10% lower than the internally mixed version of the same model because increased solar radiation at the ground increases atmospheric mixing. All of these results stem from the mixing state of black carbon. The source-oriented model representation with realistic aging processes predicts that hydrophobic diesel engine particles remain largely uncoated over the +7 day simulation period, while the internal mixture model representation predicts significant accumulation of secondary nitrate and water on diesel engine particles. Similar results will likely be found in any air pollution stagnation episode that is characterized by significant particulate nitrate production.

Field Campaign data and a Single Column Model 2

Assessment of the Aerosol Optics Component of the Coupled WRF–CMAQ Model Using CARES Field Campaign Data and a Single Column Model

Overview of the 2010 Carbonaceous Aerosols and Radiative Effects Study (Cares)

Evaluation of a new internally-mixed aerosol optics scheme in the weather research and forecasting model

Modeling Regional Aerosol and Aerosol Precursor Variability over California and Its Sensitivity to Emissions and Long-Range Transport During the 2010 Calnex and Cares Campaigns

Climate Response Due to Carbonaceous Aerosols and Aerosol-Induced SST Effects in NCAR Community Atmospheric Model CAM3.5

Understanding Aerosol–cloud Interactions Using a Single-Column Model for a Cold-Air Outbreak Case During the ACTIVATE Campaign

Coupling aerosol-cloud-radiative processes in the WRF-Chem model: Investigating the radiative impact of elevated point sources

Development of a source oriented version of the WRF/Chem model and its application to the California Regional PM<sub>10</sub>/PM<sub>2.5</sub> Air Quality Study

Development and Evaluation of an Explicit Treatment of Aerosol Processes at Cloud Scale Within a Multi‐Scale Modeling Framework (MMF)

A comparative study of two-way and offline coupled WRF v3.4 and CMAQ v5.0.2 over the contiguous US: performance evaluation and impacts of chemistry-meteorology feedbacks on air quality

Spatial and temporal variations of aerosols around Beijing in summer 2006: 2. Local and column aerosol optical properties

Reconciling Modeling with Observations of Radiative Absorption of Black Carbon Aerosols

Multi-Scale Modeling Study of the Source Contributions to Near-Surface Ozone and Sulfur Oxides Levels over California During the Arctas-Carb Period

Evaluation of modeled vertical aerosol distributions over east-Asia using in-situ and satellite data during summer 2008

Constraining chemical transport PM2.5 modeling outputs using surface monitor measurements and satellite retrievals: application over the San Joaquin Valley

Multi-year downscaling application of two-way coupled WRF v3.4 and CMAQ v5.0.2 over east Asia for regional climate and air quality modeling: model evaluation and aerosol direct effects

WRF-CMAQ two-way coupled system with aerosol feedback: software development and preliminary results

Use of Lidar Aerosol Extinction and Backscatter Coefficients to Estimate Cloud Condensation Nuclei (CCN) Concentrations in the Southeast Atlantic

The Aerosol Module in the Community Radiative Transfer Model (v2.2 and v2.3): accounting for aerosol transmittance effects on the radiance observation operator

Spatial and Temporal Variations of Aerosols Around Beijing in Summer 2006: Model Evaluation and Source Apportionment