Abstract:This paper studies an intelligent reflecting surface (IRS)-assisted wireless-powered communication network (WPCN), where a hybrid access point (HAP) broadcasts energy signals to multiple devices for their energy harvesting in the downlink (DL) and then the devices use the harvested energy to transmit information signals to the HAP in the uplink (UL) with the help of an IRS. In particular, we propose three types of IRS beamforming configurations, namely <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">fully dynamic IRS beamforming (FDBF)</i> , <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">partially dynamic IRS beamforming (PDBF)</i> , and <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">static IRS beamforming (SBF)</i> , to strike a balance between the system performance and signaling overhead as well as implementation complexity. Moreover, we adopt a practical non-linear energy harvesting (EH) model, and leverage a power-splitting (PS) EH receiver architecture with multiple rectifiers to avoid the input radio frequency power to get stuck into the saturation regime. We aim to minimize the transmit energy consumption at the HAP by jointly optimizing the DL/UL time allocation, the HAP/devices transmit power, the PS factor, and IRS phase shifts, subject to a set of minimum throughput requirements for individual devices. To address the resulting non-convex optimization problems, a successive convex approximation (SCA) based alternating optimization algorithm is proposed. Moreover, we study the case with the ideal linear EH model and two algorithms, namely SCA-based algorithm and semidefinite relaxation (SDR) algorithm, are proposed. Simulation results demonstrate the effectiveness of our proposed designs over various benchmark schemes and also unveil the importance of the joint design of IRS beamforming and PS rectifiers for achieving energy efficient WPCNs in practice.

J un 2 01 6 1 Wireless Information and Power Transfer Design for Energy Cooperation Distributed Antenna Systems

Wireless Information and Power Transfer Design for Energy Cooperation Distributed Antenna Systems

Joint Downlink and Uplink Energy Minimization in Wet-Enabled Networks

High-Efficiency Simultaneous Wireless Information and Power Transmission (SWIPT) By Exploiting 2nd/3rd Harmonics

Optimal Design of SWIPT Systems with Multiple Heterogeneous Users under Non-linear Energy Harvesting Model

Resource Allocation for Intelligent Reflecting Surface Assisted Wireless Powered IoT Systems with Power Splitting

Optimal Beamforming and Power Splitting Design for SWIPT under Non-Linear Energy Harvesting Model.

Application of Smart Antenna Technologies in Simultaneous Wireless Information and Power Transfer

Power-Efficient Passive Beamforming and Resource Allocation for IRS-Aided WPCNs

Joint TS Beamforming and Hybrid TS-PS Receiving Design for SWIPT Systems.

Multi-Objective Power Allocation for Energy Efficient Wireless Information and Power Transfer Systems

Wireless Power Transfer with Distributed Antennas: System Design, Prototype, and Experiments

Applying RIS in Multi-user SWIPT-WPCN Systems: A Robust and Environmentally-Friendly Design

Antenna Selection and Power Splitting for Simultaneous Wireless Information and Power Transfer in Interference Alignment Networks

Cognitive Wireless Power Transfer in the Presence of Reactive Primary Communication User

Distributed Power Allocation for Coordinated Multipoint Transmissions in Distributed Antenna Systems

Energy Minimization for IRS-aided WPCNs with Non-linear Power-splitting EH Model

Intelligent Reflective Surface Assisted Integrated Sensing and Wireless Power Transfer

An Optimal Energy-Efficient Transmission Design for SWIPT Systems in WSNs

Maximizing Harvested Energy for Full-Duplex SWIPT System with Power Splitting.

Wireless Information and Energy Transfer in Multi-Antenna Interference Channel.