Experimental Investigation of a Solar Collector Integrated with a Pulsating Heat Pipe and a 1 Compound Parabolic Concentrator 2

R. Xu,X. Zhang,R. Wang,S. Xu,Hua Sheng Wang

2017-01-01

Abstract:1 Experimental Investigation of a Solar Collector Integrated with a Pulsating Heat Pipe and a 1 Compound Parabolic Concentrator 2 3 Rong Ji Xu , Xiao Hui Zhang, Rui Xiang Wang, Shu Hui Xu, Hua Sheng Wang 4 1 Beijing Engineering Research Center of Sustainable Energy and Buildings, 5 Beijing University of Civil Engineering and Architecture, Beijing, 100044, China 6 2 School of Engineering and Materials Science, Queen Mary University of London, London, E1 4NS, UK 7 8 Abstract: The paper reports an experimental investigation of a newly proposed solar collector that 9 integrates a closed-end pulsating heat pipe (PHP) and a compound parabolic concentrator (CPC). 10 The PHP is used as an absorber due to its simple structure and high heat transfer capacity. The CPC 11 has a concentration ratio of 3.4 and can be readily manufactured by three-dimensional printing. The 12 CPC can significantly increase the incident solar irradiation intensity to the PHP absorber and also 13 reduce the heat loss due to the decrease in the area of the hot surface. A prototype of the solar 14 collector has been built, consisting of a PHP absorber bent by 4 mm diameter copper tube, CPC 15 arrayed by 10×2 CPC units with the collection area of 300×427.6 mm, a hot water tank and a glass 16 cover. HFE7100 was utilized as the working fluid at a filling ratio of 40%. The operating 17 characteristics and thermal efficiency of the solar collector were experimentally studied. The steady 18 and periodic temperature fluctuations of the evaporation and condensation sections of the PHP 19 absorber indicate that the absorber works well with a thermal resistance of about 0.26 °C/W. It is 20 also found that, as the main factor, the thermal performance of the collector decreases with 21 increasing evaporation temperature. The collector apparently shows start-up, operational and 22 shutdown stages at the starting and ending temperatures of 75 °C. When the direct normal 23 irradiance is 800 W/m, the instantaneous thermal efficiency of the solar collector can reach up to 24 50%. 25