Data Report: Trace Element Geochemistry of the Blake Ridge Sediments at Site 997
Y. Watanabe,R. Matsumoto,H. Lu
DOI: https://doi.org/10.2973/odp.proc.sr.164.223.2000
2000-01-01
Abstract:Twenty-two trace elements in 355 sediment samples from Site 997 on the Blake Ridge were examined by inductively coupled plasma-optical emission spectrometry and inductively coupled plasma-mass spectrometry, for respective fractions of acidsoluble and insoluble compositions. Downhole profiles of these elements exhibit complicated fluctuations throughout late Miocene to Pleistocene, principally due to the variations in the acid-soluble fraction. Noncarbonate composition is given from the acid-insoluble residues, which permits us to recognize secular feature of selected element variance for four intervals. These intervals (I: 0–183 mbsf; II: 183– 440 mbsf; III: 440–618 mbsf; and IV: 618–750 mbsf) are interpreted to have originated from changes in the suite of sediments of particular sources and chemical composition, sedimentation rate, dilution of biogenic carbonate abundance, and possibly the current system that controlled deposition and reworking of the terrigenous materials. INTRODUCTION Site 997 is located on the crest of the Blake Ridge, which extends southeastward more than 500 km from the North American Continental Rise (Fig. 1). During Leg 164, three sites were drilled on the Blake Ridge (Sites 994, 995, and 997) that exhibit uniform, rather homogeneous silty-clayey lithologies comprising biogenic and terrigenous sediments through the upper Miocene to Holocene (Paull, Matsumoto, Wallace, et al., 1996). The Blake Ridge has been drilled during several previous DSDP cruises (DSDP Legs 11 and 76); since then much interest has developed, particularly on the gas hydrate occurrences and carbonate diagenesis (Hollister, Ewing, et al., 1972; Sheridan, Gradstein, et al., 1983). The sediment deposition on the Blake Ridge has been attributed to the Western Boundary Undercurrent along the northwestern Atlantic (Heezen et al., 1966). Contourite deposition was first noted as reddish sediment originating from upper Carboniferous sediments in southeastern Canada (Needham et al., 1969), which also has been confirmed during Leg 164 as having occurred from the late Miocene through the Pleistocene (Paull, Matsumoto, Wallace, et al., 1996). Sedimentation rates are generally equivalent among Sites 994, 995, and 997 on the Blake Ridge, gradually decreasing from late Miocene to Holocene (i.e., 40 to 68 m/m.y. for the entire Quaternary, 89–133 m/m.y. for the late Pliocene, 140–160 m/m.y. for the early Pliocene, and 256 to 340 m/m.y. for the late Miocene; Paull, Matsumoto, Wallace, et al., 1996). Through these time periods, lithologic facies appear to be constant throughout the section. The longest composite section (750 m) was recovered from two holes at Site 997 (Holes 997A and 997B; Fig. 2) and extends into the late Miocene, based on shipboard biostratigraphy. Thus, Site 997 is the most suitable site for establishing the stratigraphic variation of the sediments of the Blake Ridge. This paper reports the results of shore-based analyses of trace element geochemistry for sediments from Site 997. The major element geochemistry is reported separately (Lu et al., Chap. 14, this volume). 1Paull, C.K., Matsumoto, R., Wallace, P.J., and Dillon, W.P. (Eds.), 2000. Proc. ODP, Sci. Results, 164: College Station, TX (Ocean Drilling Program). 2Mineral and Fuel Resources Department, Geological Survey of Japan, Tsukuba, Ibaraki 305-8567, Japan. nabe@gsj.go.jp 3Geological Institute, School of Sciences, The University of Tokyo, Hongo, Tokyo 113, Japan. 4Present address: Technology Research Center, Japan National Oil Corporation, 1-2-2, Hamada, Mihama-ku, Chiba 261-0025, Japan. The objective of this report is to present a chemical stratigraphy of the Blake Ridge section from the late middle Miocene to Holocene period, based on trace sediment geochemistry. SAMPLES AND METHODS OF ANALYSIS Three hundred fifty-five sediment samples from Site 997 were examined for geochemistry and mineralogy. The sampling interval was ~150 cm because the sediments were collected from every available section of cores from Holes 997A and 997B. Sediment samples of approximately 5 cm3 were twice washed with deionized water and then recovered in wet condition by centrifuging. They were dried at room temperature and then powdered in an agate mortar. A portion of each powdered sample was sent to the University of Tokyo for mineralogical and major element analysis (Lu et al., Chap. 14, this volume). A 0.1000 g subsample was used for the trace element analyses. To prevent precipitation of insoluble CaF2 in the mixed acid digestion, the powdered samples were soaked in 1.0 M acetic acid solution for two nights at room temperature to recover the soluble carbonate fraction (mainly of calcite and dolomite). This solution was separated by centrifugation, and the residual solids were dried in an oven below 90°C. 82 ° 80 ° 78 ° 76 ° 74°W