A fixed-grid fluid structure interaction method for fully- coupled compressible solid and incompressible fluid

Song Yu

2018-01-01

Abstract:In this paper, we develop a fixed-grid fluid-structure interaction method immersed volume method to solve the fluid structure interaction problem. In this method, the fluid mesh exists in the whole fluid and solid domain, and the solid is regarded as real occupation overlap the fluid domain. The fluid equations are solved in the whole FSI domain. While the fluid and solid interaction conditions are only transmitted on the fluid-structure interface. The proposed method avoids the interaction of the fluid and solid velocity except on the fluid-structure interface and has strong ability to solve the FSI problems for the compressible solid and the incompressible fluid. A 2D flow passing and elastic wall problem is simulated using the IVM. The solid deformation and fluid pressure variation shows good agreement with the traditional Arbitrary Lagrangian Eulerian method. A rotating rotor in a cavity is then computed to testify the robust of the boundary tracking scheme. INTRODUCTION Fluid-structure interaction (FSI) is a crucial consideration in the design of many engineering systems problems, e.g. hydraulic machinery, nuclear equipment. The main challenge to solve these problems arises from their strong nonlinearity and multidisciplinary nature. For most FSI problems, analytical solutions to the governing equations are impossible to obtain, whereas laboratory experiments are limited in scope. Therefore, to investigate the fundamental physics involved in the complex interaction between fluids and solids, numerical method plays an important role. In the past few decades, numerous works has been done to develop more robust and efficient techniques to simulate the FSI problems.A general classification of the FSI solution procedures is based upon the mathematically treatment of meshes: the conforming mesh methods and non-conforming mesh methods. The conforming mesh methods are commonly applied to solve the coupling issues with simple physical meanings, such as the Arbitrary Lagrangian Eulerian (ALE) approach [1, 2]. In this approach, the fluid and solid computational domain are separated by the fluid-structure interface, where the information is communicated. As the solid deforming with time, the fluid computational domain varies, when re-meshing is inevitable. The conforming mesh approach could integrate available disciplinary algorithms which have been validated and used for solving many complicated fluid or structural problems. However, the re-meshing process in each time step is computational expensive and could cause distorted mesh or even divergence results when the solid suffers large deformation. The non-conforming mesh method is developed to overcome the above problem. The most prominent non-