Tungsten control in nbi-dominant h-mode discharges in east tokamak

L. Zhang,S. Morita,X. D. Yang,Z. Xu,X. Z. Gong,M. H. Li,Y. M. Duan,Y. Y. Li,Y. W. Sun,J. Huang,F.,Ding,L. Wang,Y. Liu,Q. Zang,H. Q. Liu,G. S. Xu,Z. W. Wu,H. Y. Guo,C. D. Hu,J. L. Chen,Q. L.,Hu,Y. F. Liang,X. D. Zhang
2018-01-01
Abstract:In EAST tokamak, H-mode discharges have been obtained at various heating conditions despite the installation of tungsten monoblocks at upper divertor. Recently, a reproducible long pulse H-mode operation with sufficient tungsten suppression has succeeded for both electron cyclotron resonance (ECR) and lowerhybrid wave (LHW) heated discharges, and various experimental approaches are also attempted for the tungsten suppression. In discharges dominantly heated by neutral beam in jection (NBI), however, the long pulse H-mode operation has been often restricted by appearance of the tungsten accumulation. In order to control the tungsten accumulat ion in the NBI H-mode discharges, experiments have been done by superimposing the LHW heating. Since plas ma particles are pumped out after switching on the LHW pulse, the tungsten concentration is largely reduced in the plasma core, while the tungsten emission in the plasma outer region is also reduced. In addition, radial profiles of line emissions from highly ionized tungsten ions and radiation measured with AXUV and soft x-ray arrays show that the tungsten distribution is considerably flattened during the LHW pulse, although the tungsten ions accumulate in a very narrow region of core p lasmas (ρ<0.2) during the NBI phase. The results clearly indicate effects of the LHW on edge screening and core transport of tungsten ions in the NBI H-mode discharge. When the power rat io of PLHW/PNBI is relatively high, e.g. ~0.9, the tungsten concentration is sufficiently reduced by an order of magnitude. A beneficial ro le on the LHW injection to control the tungsten concentration in the NBI discharge is observed for the first time in EAST suggesting a potential way toward steady-state H-mode NBI operation.
What problem does this paper attempt to address?