Revision 1 1 Changes of antigorite cell parameters close to the antigorite 2 dehydration reaction at subduction zone conditions

TINGTING SHEN,CONG ZHANG,JING CHEN,JÖRG HERMANN,ZHANG,JOSÉ ALBERTO PADRÓN-NAVARTA,LI CHEN,XU JUN,JINGSUI,YANG
2019-01-01
Abstract:20 The length of the antigorite a-axis (usually expressed as the polysome m value) has 21 been investigated as a function of temperature and pressure in the range of 22 600-650 °C, 25-45 kbar in weeklong piston cylinder experiments. A 23 well-characterised natural antigorite (with m=16 and less abundant m=15) was used as 24 starting material that coexisted with olivine, chlorite, Ti-humite phases and aqueous 25 fluid at run conditions. Transmission electron microscope (TEM) measurements on 26 selected FIB wafers showed that antigorite m values after the experiments varied 27 between 14 and 22. More than 40 punctual analyses for each run condition were 28 acquired to determine the range and the dominant m value. The antigorite peak m 29 value decreased systematically from 17-19 at 600 °C to 15-16 at 650°C. The spacing 30 of the m-isolines is getting narrower as the antigorite breakdown reaction is 31 approached. The topology of the m-isolines is similar to previous experiments in the 32 simple MSH-system, however the isolines are shifted to about 50-100°C higher 33 temperatures due to the incorporation of Al into antigorite. Powder samples and FIB 34 wafers of natural antigorite from the Tianshan UHP belt (China) with peak 35 metamorphic conditions of ~35 kbar, ~520 °C were also investigated with TEM. Low 36 Al-antigorite formed at peak metamorphic conditions displays a peak m value of 37 20-21, whereas high-Al antigorite formed during isothermal decompression displays a 38 lower m value of 19. The experimental results and the new UHP antigorite 39 measurements are combined with published data of m values from metamorphic 40 antigorite that experienced variable conditions in order to construct a P-T-m diagram 41 that can be used in future studies to better constrain formation conditions of 42 serpentinites. The decrease of m values and the increase of Al in antigorite with 43 increasing temperature result in a small, continuous dehydration whereby the H2O 44 content of antigorite changes from 12.4 to 12.1 wt.%. Therefore, it is expected that a 45 pore fluid is present during the prograde deformation of serpentinites. TEM 46 observations on the experiments showed that antigorite adjusted its Al content by 47 segregation of chlorite at the nanoscale. Together with the observation that always 48 multiple m values are present in a single sample this indicates that full equilibration of 49 antigorite at the micron-scale is rare, with important implications for the interpretation 50 of geochemical signatures obtained by in-situ techniques. 51
What problem does this paper attempt to address?