BL1A Formation of Active Mo Species Supported on SiO2-Al2O3 for Dehydroaromatization:Mo LIII-edge XANES Study

J. Ding,B. H. Sun,T. X. Fan,D. Zhang,M. Kamada,K. Kuwahara,H. Ogawa,Q. X. Guo
2013-01-01
Abstract:MoO3-modified H-MFI shows high activity for dehydroaromatization of methane, although strong deactivation cannot be avoided during the reaction. In this reaction, many workers have been revealed reduction of Mo species is brought about in contact with methane in the initial step. Deoxidated Mo ions react methane to form carbide species, Mo2C, in the second stage. The carbide species is active for dehydroaromatization of methane to form benzene, however, deactivation is brought about by carbon deposition on the catalyst surface at the same time. It is likely the catalytic activity and its deactivation rate depend on the type of silica-alumina supports. Relation between silica-alumina support and active Mo species formed in the reaction is important to clarify the formation process of highly active Mo species and its red-ox behavior during the reaction. In fact, molybdena species supported on amorphous silica-alumina shows dehydroaromatization activity while it is very lower than that on H-MFI support. By comparing H-MFI with amorphous silica-alumina supports, reduction behavior of Mo ions before/after the reaction can be provided. Characterizaiton of those species by means of Mo L-edge XANES is appropriate for clarification of Mo ions with different valences. In this report, local structure of supported Mo ions on H-MFI and amorphous silica-alumina (SAH-1) and their redox changes after dehydroaromatization of methane or ethane at 973 K for 3 h is evaluated by Mo LIII-edge XANES. Experimental Mo LIII-edge XANES spectra were measured in BL1A of UVSOR-IMS in total-electron yield (TEY) mode, using the Ge(111) double-crystal monochromator (2d = 0.6532 nm). The photon energy was calibrated by using Mo metal sample at Mo LIII-edge (2520 eV). Results and Discussion Fig. 1 shows the XANES spectra of authentic Mo samples. It is clear that both intensity and energy positions of two white-lines are different between Na2MoO4 (consist of MoO4 tetrahedra, Td) and MoO3 (Mo-O6 octahedra, distorted Oh) because of local symmetry around Mo ions. In cases of Mo2C (Mo) and Mo metal, edge energy values of those XANES are lower than Mo samples, however, difference of edge energy is unclear between Mo2C and Mo metal. To clarify the difference, second derivative XANES were introduced, as shown in Fig. 2. As for the 2nd derivative waves, minimum peaks are due to peak components of original XANES. The difference of energy value is significantly between Mo2C (2524.2 eV as lowest energy) and Mo mettal (2523.5 eV). The assignment can be applied to the catalyst samples with reduced Mo ions. Fig. 3 shows the XANES spectra of MoO3/SAH-1 and MoO3/H-MFI catalysts before/after the reaction with CH4 or C2H4 at 973 K. For MoO3/SAH-1, it is concluded that reduced Mo species are formed after C2H4 reaction but not formad after CH4 reaction. In case of MoO3/H-MFI, which shows high catalytic activity for converting CH4 to C6H6, several components due to Moand Mo(peak at 2526.5 eV) species are overlapped after CH4 reaction. This result suggests the formation of so-called “oxy-carbide species” as catalytically active species for dehydroaromatization of CH4. After C2H4 reaction, Mo-species is only formed and the component due to Mo-species is scarcely seen. The reactivity for converting C2H4 to C6H6 is higher in MoO3/SAH-1 than in MoO3/H-MFI. In addition, crystallinity of MFI-phase in MoO3/H-MFI became low only by the reaction with C2H4 by XRD analysis, suggesting catalytic deactivation during the reaction. Thus it is concluded that difference between H-MFI and SAH-1 supports gives the formation of Mo species with different reduction state after the reaction with CH4. Partly reduced oxy-carbide species coexisting Mo and Mo ions are formed on H-MFI support after contact with CH4, and this species can act as highly active species for CH4 dehydroaromatization.
What problem does this paper attempt to address?