Synthesis and raman studies of three martian hydrated sulfates

Haijun Cao,Zongcheng Ling,Jian Chen,Yuheng Ni,Xiaojin Xie
2017-01-01
Abstract:Introduction: Hydrated sulfates have been widely observed by martian orbital remote sensing (by OMEGA instrument on Mars Express and CRISM instrument on Mars Reconnaissance orbiter, MRO). Although many types of sulfates (e.g., Ca, Mg, Fe-sulfate) were found to be widespread and in large quantities [1], there are still unknowns about the complex phases especially the Fe-sulfate se-ries . Mixed-valences Iron (II) and iron (III) sulfates were found in evaporate deposits and might exist as romerite (FeFe2(SO4)4∙14H2O) and halotrichite (FeAl2(SO4)4∙22H2O) [2]. The Mars Exploration Rover (MER) Spirit excavated soils with high albedo and relatively white to yellow colors at Paso Robles in Gusev crater and Paso Robles soils may contain coquimbite (Fe2(SO4)3∙9H2O)[3]. Raman spectroscopy as a promising planetary spectroscopy technique for studying Martian sulfate will be applied in future Mars missions (e.g., ExoMars and Mars 2020) [4]. Many hydrated sulfates have also been identified at acid mine drainage (AMD) system on Earth [5-7]. But they are often in mixtures without pure phase, Raman spectra of natural sulfates have been conducted by relevant Raman flyby instruments [8]. Meanwhile, conditions of synthesizing process of sulfates can reflect past Martian environment under which formation of sulfates need proper PH, relative humidity (RH), temperature (T), Martian relative pressure (P) and partial water pressure (PH2O), etc [9]. Thus we can infer past and present environmental conditions of the Martian surface and subsurface in order to better understand the geological evolution of the Mars. This paper focuses on the spectroscopic characterizations of three synthesized Fe-sulfates, i.e., halotrichite, romerite, and coquimbite. Our goal is to obtain pure phases of these sulfates and acquire their exact spectroscopic properties for their potential utilizations in future martian remote sensing and in situ investigations. Sample synthesis Halotrichite: A single batch of saturated aqueous solution of iron (II) sulfate and alumi-num sulfate were prepared using AR grade mate-rials by dissolving FeSO4∙7H2O and Al2(SO4)3∙18H2O. We took out 15 ml each saturated aqueous solution of iron (II) sulfate and aluminum sulfate. Each of the material used to prepare the saturated solution were placed into the beaker and need fix two soxhlet extraction thimbles on the beaker wall. Then we added adequate solid powder of FeSO4∙7H2O and Al2(SO4)3∙18H2O to the two soxhlet extraction thimbles in order to make aqueous solution of each soxhlet extraction thimble achieve saturation. Solid powders were repeatedly added in for 7 days and then the residuary solution of baker was heated in an
What problem does this paper attempt to address?