Abstract:Abstract. Atmospheric aerosols are a significant public health hazard and have substantial impacts on the climate. Secondary organic aerosols (SOAs) have been shown to phase separate into a highly viscous organic outer layer surrounding an aqueous core. This phase separation can decrease the partitioning of semi-volatile and low-volatile species to the organic phase and alter the extent of acid-catalyzed reactions in the aqueous core. A new algorithm that can determine SOA phase separation based on their glass transition temperature (Tg), oxygen to carbon (O:C) ratio and organic mass to sulfate ratio, and meteorological conditions was implemented into the Community Multiscale Air Quality Modeling (CMAQ) system version 5.2.1 and was used to simulate the conditions in the continental United States for the summer of 2013. SOA formed at the ground/surface level was predicted to be phase separated with core–shell morphology, i.e., aqueous inorganic core surrounded by organic coating 65.4 % of the time during the 2013 Southern Oxidant and Aerosol Study (SOAS) on average in the isoprene-rich southeastern United States. Our estimate is in proximity to the previously reported ∼70 % in literature. The phase states of organic coatings switched between semi-solid and liquid states, depending on the environmental conditions. The semi-solid shell occurring with lower aerosol liquid water content (western United States and at higher altitudes) has a viscosity that was predicted to be 102–1012 Pa s, which resulted in organic mass being decreased due to diffusion limitation. Organic aerosol was primarily liquid where aerosol liquid water was dominant (eastern United States and at the surface), with a viscosity <102 Pa s. Phase separation while in a liquid phase state, i.e., liquid–liquid phase separation (LLPS), also reduces reactive uptake rates relative to homogeneous internally mixed liquid morphology but was lower than aerosols with a thick viscous organic shell. The sensitivity cases performed with different phase-separation parameterization and dissolution rate of isoprene epoxydiol (IEPOX) into the particle phase in CMAQ can have varying impact on fine particulate matter (PM2.5) organic mass, in terms of bias and error compared to field data collected during the 2013 SOAS. This highlights the need to better constrain the parameters that govern phase state and morphology of SOA, as well as expand mechanistic representation of multiphase chemistry for non-IEPOX SOA formation in models aided by novel experimental insights.

Sensitivity of a Q-ACSM to Chamber Generated SOA with Different Oxidation States

Sensitivity of a Q-ACSM to chamber generated SOA with differentoxidation states

Response factor of a Q-ACSM to chamber generated SOA with different average oxygen content 2

Analytical advances to study the air-water interfacial chemistry in the atmosphere

Aqueous aging of secondary organic aerosol coating onto black carbon: Insights from simultaneous L-ToF-AMS and SP-AMS measurements at an urban site in southern China

Evaluation of aerosol chemical speciation monitor response to different mixtures of organic and inorganic aerosols

Modeling the Molecular Composition of Secondary Organic Aerosol under Highly Polluted Conditions: A Case Study in the Yangtze River Delta Region in China

Aerosol Mass Yields of Selected Biogenic Volatile Organic Compounds – a Theoretical Study with Nearly Explicit Gas-Phase Chemistry

Research on Formation and Aging of Secondary Organic Aerosol Based on Simulation Methods

Response of the Aerodyne Aerosol Mass Spectrometer to Inorganic Sulfates and Organosulfur Compounds: Applications in Field and Laboratory Measurements

Secondary Organic Aerosol Formation and Aging from Ambient Air in an Oxidation Flow Reactor During Wintertime in Beijing, China.

Review of the influencing factors of secondary organic aerosol formation and aging mechanism based on photochemical smog chamber simulation methods

Laboratory simulation for the aqueous OH-oxidation of methyl vinyl ketone and methacrolein: significance to the in-cloud SOA production

Ambient Quantification and Size Distributions for Organic Aerosol in Aerosol Mass Spectrometers with the New Capture Vaporizer

Effects of Aqueous-Phase and Photochemical Processing on Secondary Organic Aerosol Formation and Evolution in Beijing, China.

Measurement Report: A new coupled method of pH titration and size-resolved analysis to identify the structure, aging, and source of water-soluble organic carbon

Exploring the discrepancies between SMPS and AMS measurements in secondary organic aerosol formation experiments

Laboratory studies of the chemical composition and cloud condensation nuclei (CCN) activity of secondary organic aerosol (SOA) and oxidized primary organic aerosol (OPOA)

Predicting secondary organic aerosol phase state and viscosity and its effect on multiphase chemistry in a regional-scale air quality model

Combined Smog Chamber/Oxidation Flow Reactor Study on Aging of Secondary Organic Aerosol from Photooxidation of Aromatic Hydrocarbons

Trends in the oxidation and relative volatility of chamber-generated secondary organic aerosol