Influence of Axial Installation Deviation on the Hydraulic Axial Force of the 1000 MW Francis Runner in the Rated Operating Condition
Yongsheng Liu,Chengming Liu,Yongsheng Zhang,Xingxing Huang,Tao Guo,Lingjiu Zhou,Zhengwei Wang
DOI: https://doi.org/10.3390/en16041878
IF: 3.2
2023-01-01
Energies
Abstract:To study the influence of the axial installation deviation of the runner on the hydraulic axial force of the 1000 MW Francis turbine unit, geometric models of the full flow passage of the Francis turbine with the runner sinking in the axial direction by 0, 0.5, 1, 1.5, 2.5, 4, and 5.5 mm were established. The geometric models of the upper crown clearance, lower band clearance, and pressure balance pipes were also built. The SST turbulence model was used in the CFD setup to numerically simulate the flow in the Francis turbine with different runner installation sinking values. The results show that the hydraulic axial force on the inner surface of the runner remains stable when the runner is lowered. The hydraulic axial force on the entire runner surface and the outer surface of the lower band decreases, and the hydraulic axial force on the outer surface of the upper crown clearance increases. All of these hydraulic axial forces gradually tend to stabilize as the amount descending from the runner increases. To study the reasons for the changes in hydraulic axial forces, the streamlines and fluid fields of different sections in the flow passage were analyzed in detail. It was found that periodic changes of vortices were generated in the clearance due to the influences of the geometric shape and wall rotation. These vortices affect the distribution of velocity and pressure and, thus, determine the hydraulic axial forces. The runner axial installation deviation has little influence on the streamlines, pressure, and velocity distribution in each flow passage, and only changes the velocity and pressure in the upper crown clearance and lower band clearance. Therefore, the axial installation deviation of the runner has a great effect on the hydraulic axial force on the outer surface of the upper crown and lower band and has a smaller impact on the runner passage and the hydraulic axial force on the inner surface of the runner. The conclusions in this study can be adopted as references for the installation accuracy control of other hydraulic Francis turbine units.