Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Research on Performance of Space Cycling Centrifugal Pump in Microgravity

Cavitation Performance of the Low Specific-speed Centrifugal Pump with Radial Reflux Balance Hole

Research on the Performance of a Passive Gas-Liquid Separator Used in Space

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Study on external performance and internal flow characteristics in a centrifugal pump under different degrees of cavitation condition

Experimental investigation of liquid transport in a vane type tank of satellite with microgravity

Experimental Study of Cavitation Phenomenon in A Centrifugal Blood Pump Induced by the Failure of Inlet Cannula

Study of the Flow in a Cryogenic Pump under Different Cavitation Inducements by Considering the Thermodynamic Effect

Liquid-vapor two-phase flow in centrifugal pump: Cavitation, mass transfer, and impeller structure optimization

Cavitation in a shaft-less double suction centrifugal miniature pump

Experiment and Numerical Simulation of Cavitation Performance for a Double Suction Centrifugal Pump

Research on Improving Cavitation Performance and Based on CFD of Centrifugal Pump

Numerical Simulation and Analysis of Cavitation Flows in a Double Suction Centrifugal Pump

Numerical Simulation on Interface Evolution and Pressurization Behaviors in Cryogenic Propellant Tank on Orbit

Numerical Research on the Cavitation Characteristics for Typical Conditions of A Centrifugal Pump with Whole Flow Passage

Analysis of Cavitation Behaviour in A Centrifugal Pump

Research on the Performance of a Centrifugal Aviation Fuel Pump Based on Response Surface Methodology

Investigation of cavitation characteristics in an aircraft centrifugal fuel pump

Static profiles of capillary surfaces in the annular space between two coaxial cones under microgravity