Pitch angle optimization of variable speed pitch control HAWTs

Ding,Yong-Gang,Zhang,Xing,Li,Mei-Zhi
2016-01-01
Kung Cheng Je Wu Li Hsueh Pao/Journal of Engineering Thermophysics
Abstract:Wind energy density drops for air density decreases in high altitude area.To capture more wind power,one way is to enlarge rotor swept area which means longer blade.Another way is to adjust the control,especially the yaw and pitch system,of wind turbines.The pitch angle is 0° when design a blade,that is the best power coefficient (Cp) at design status.However,Cp is no longer the best at 0° if it is not at design status.This paper optimized the pitch angle of a conventional variable speed pitch control HAWT,and ensured that Cp is the best at each wind speed before rated to increase total power.A 42 m blade for 1.5 MW wind turbine was chosen for case study.Its optimal pitch angle curve and a fitted curve were obtained.Furthermore,power curve and AEP with and without pitch optimization at altitude of 3000 m and 4000 m were calculated and compared.The result shows that Cp increases most before rated.The higher altitude,the lower air density,and the effect of pitch optimization is more obvious.This paper is only concerning about aerodynamic enhancement,however,the influence to extreme and fatigue loads of the blade needs further investigation.
What problem does this paper attempt to address?