Abstract:The new power system with increasingly high renewable energy proportion necessitates the combined heating and power (CHP) generation units to provide more flexibility. With full consideration of operation characteristics, this paper firstly proposes an advanced coal-fired CHP-CAES system consisting of a 350 MW coal-fired CHP unit and a 30 MW CAES system, which realizes more efficient energy utilization and enhances the system adjusting flexibility through thermal cycles integration and energy comprehensive utilization. The thermodynamic models and multi-dimensional performance analysis models are separately established. Based on that, the comparative study is conducted for two CHP-CAES configurations and the stand-alone CHP unit. With 80% heating load, the minimum power ratio is lowered by 11.69% rated power and the maximum power output is increased by 6.35% rated power, and 27.26 tons of coal can be saved for a single cycle compared with the stand-alone CHP unit. The results also demonstrate that the system still has superiority when the load ratio changes. Techno-economic evaluations for a typical application scene show that the dynamic payback period of the proposed system is shortened by 10.41 years compared with the reference separate CHP-CAES system. These results show that the proposed system presents better performance in energy utilization, enhancing flexibility, realizing clean and low-carbon heating as well as techno-economics. In addition, parametric analysis is implemented to find the influence of CAES parameters on the system. It is found that increasing the expander inlet temperature and air storage pressure can further enhance the system round-trip performance. Yet, the investment cost increases greatly for higher storage pressure and the payback period will be lengthened. Furthermore, the system advantages are strengthened with a CAES system of greater capacity. Nevertheless, we find that the deep coupling in the thermodynamic cycle of the two systems results in an upper capacity for the integrated CAES system, and it is nearly 35 MW for the studied system. These regularities and conclusions can provide theoretical guides and directions for the customized CAES system design with the purpose to integrate with a coal-fired CHP unit.

Overall energy efficiency and flexibility retrofit scheme analysis of heat-power integrated energy system

Comparative study for four technologies on flexibility improvement and renewable energy accommodation of combined heat and power system

Comparative Study on Heating and Cooling Systems Integrated with Energy Storage

Optimal Coordination of Chp Plants with Renewable Energy Generation Considering Substitutability Between Electricity and Heat

Exploiting Flexibility of District Heating Networks in Combined Heat and Power Dispatch

Capacity configuration optimization for the CCHP system considering integrated demand response

Thermodynamic analysis of the coal-fired combined heat and power units integrated with steam ejectors and thermal storage

Thermodynamics, flexibility and techno-economics assessment of a novel integration of coal-fired combined heating and power generation unit and compressed air energy storage

Enhancing Power Supply Flexibility in Renewable Energy Systems with Optimized Energy Dispatch in Coupled CHP, Heat Pump, and Thermal Storage

Energy Management of CHP-Based Microgrid with Thermal Storage for Reducing Wind Curtailment

Optimal operation of integrated power and thermal systems for flexibility improvement based on evaluation and utilization of heat storage in district heating systems

Optimized Dispatching for Integrated Energy System with Wind Power

Thermodynamic and Economic Analysis of a Gas-Turbine Combined Heat and Power Plant Considering Operational Flexibility

Improve the Integration of Renewable Energy Sources Into Power System by the Usage of Phase-change Heat Storage

A New Boiler-turbine-heating Coordinated Control Strategy to Improve the Operating Flexibility of CHP Units

Coordinated Heat and Power Dispatch of Microgrid Considering Two-dimensional Controllability of Heat Loads

Energy saving scheduling of power and two steam loads for a CHP system consisting of multiple CHP units integrated with steam ejectors

Study on a Novel Co-Operated Heat and Power System for Improving Energy Efficiency and Flexibility of Cogeneration Plants

Phase-Change Heat Storage Installation in Combined Heat and Power Plants for Integration of Renewable Energy Sources into Power System

Multi-Technical Flexibility Retrofit Planning of Thermal Power Units Considering High Penetration Variable Renewable Energy: The Case of China

Increasing the Flexibility of Combined Heat and Power for Wind Power Integration in China: Modeling and Implications