Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Efficiency Analysis for Electric Motor-vane Pump Prototype with Port-plate Centrifugal Pump

An Investigation in Performance of a Variable-Speed-Displacement Pump-Controlled Motor System

Virtual prototype technology for axial piston pumps used in seawater desalination

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Study on Control Performance of Digital Piston Pump Based on Virtual Prototype Technology

Research on Pressure Pulsation Characteristics of Axial Piston Pump Based on Virtual Prototype

Finite Element Analysis on Piston of Axial Piston Pump Based on Virtual Prototype

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Modeling and Simulation on Axial Piston Pump Based on Virtual Prototype Technology

High Efficiency and Low Pressure Fluctuation Redesign of A Centrifugal Pump Based on Unsteady Cfd Analyses

Investigation on the Energy Exchange Characteristics of the Regenerative Flow Pump in an Automobile Fuel System

Computational Fluid Dynamics-Based Pump Redesign to Improve Efficiency and Decrease Unsteady Radial Forces

Improvement Design of a Vertical Double-stage Self-priming Pump

Development of an Intelligent Electric Motor-Driven Pump with High Energy Efficiency

Analysis of vane loads and motion in a hydraulic double vane pump with integrated electrical drive

Optimization of Magnetic Pump Impeller Based on Blade Load Curve and Internal Flow Study

Energy Balance Analysis for a Canned Motor Pump Used for Heat Supply System

A Double-Rotating Ferrofluid Vane Micropump with an Embedded Fixed Magnet

Performance analysis and experimental verification of hydraulic driven axial flow pumps