Abstract:Modern structures on aircraft make increasing use of large-scale composite structures. Quantitative damage monitoring for composites, including damage occurrence, number, localization, and size estimation, will help reduce maintenance costs, improve fleet management efficiency through condition-based maintenance, and potentially more rapidly enable new material systems and structural concepts by integrating health monitoring into the design itself. With the advantage of easily interpretable, intuitive, and accurate imaging result, the delay-and-sum imaging algorithm is frequently researched and applied to damage monitoring. However, when it is applied to multidamage monitoring in large-scale composites, the consumed time and computation resource are too much for pixel value calculation. Besides, due to the material anisotropy and existence of bolt holes and stiffeners in the researched complex carbon fiber composite laminate, propagation mechanism of Lamb wave is quite complicated, which makes the conventional localization result not accurate by delay-and-sum algorithm according to the point with pixel peak value. What is more, the imaging quality is deteriorated with concurrence of multiple damages, and thus, quantitative damage information cannot be extracted. Hence, the damage index merging algorithm is introduced for quick damage identification and damage merging in every subarea divided by piezoelectric sensor array. The delay-and-sum imaging algorithm is performed afterward only in subareas identified with damages, which significantly improves the efficiency of damage imaging for large-scale composites. The nonlinear normalization of pixel values compensates the deterioration of multidamage imaging quality. Then, a weighted average algorithm is introduced for more accurate localization. A further damage size level estimation is realized with probabilities by extracting the image pixel peak value. Experiments with six damages simultaneously on the complex carbon fiber laminate verify the effectiveness of the proposed quantitative multidamage monitoring algorithm with localization error below 2 cm and correct damage number and size level estimation.

Probability-based diagnostic imaging for damage identification of stiffened composite panel

Lamb Wave-Based Damage Localization and Quantification in Composites Using Probabilistic Imaging Algorithm and Statistical Method

An Improved Adjacent Wave Subtraction Method for Damage Detection in Stiffened Composite Panels

Rapid Damage Reconstruction Imaging of Composite Plates Using Non-Contact Air-Coupled Lamb Waves

An Electromechanical Impedance‐Based Imaging Algorithm for Damage Identification of Chemical Milling Stiffened Panel

Elliptical Ring Distribution Probability-Based Damage Imaging Method for Complex Aircraft Structures

Composite delamination damage location based on non-orthogonal air-coupled ultrasonic guided waves and Artifact-Reduction damage index

Experiments for the Assessment of the Probabilistic Multistage Algorithm for Damage Detection in Flat and Curved CFRP Panels

Damage Detection Method Based on Lamb Waves for Stiffened Composite Panels

A Modal Decomposition Imaging Algorithm for Ultrasonic Detection of Delamination Defects in Carbon Fiber Composite Plates Using Air-Coupled Lamb Waves

Damage Identification in Various Types of Composite Plates Using Guided Waves Excited by a Piezoelectric Transducer and Measured by a Laser Vibrometer

Rapid Multi-Damage Identification for Health Monitoring of Laminated Composites Using Piezoelectric Wafer Sensor Arrays

A Combined Static/Dynamic Technique for Damage Detection of Laminated Composite Plates

A Novel Methodology to Research the Residual Compressive Mechanical Properties of Composite Stiffened Panel after Low Velocity Impact Based on Quantification Damage Simulation

Application of Wave Propagation Analysis for Damage Identification in Composite Laminated Beams

Probabilistic Diagnostic Algorithm-Based Damage Detection for Plates with Non-uniform Sections Using the Improved Weight Function

A damage imaging method based on particle swarm optimization for composites nondestructive testing using ultrasonic guided waves

A quantitative multidamage monitoring method for large-scale complex composite

Damage Identification Method Based on Ultrasonic Guided Wave Sensor Network and Path Optimization Bayesian Fusion Algorithm

Structural Damage Identification Based on Integrated Utilization of Inverse Finite Element Method and Pseudo-Excitation Approach

Inspection of defects in composite structures using long pulse thermography and shearography