Abstract:The dynamic model, particularly with reference to controller design, is an important issue in mechanical control and design. However, this model is often difficult to achieve in complex multi-closed-loop mechanisms, such as parallel mechanisms or forging manipulators. A new approach on the dynamic modeling of a multi closed-chain mechanism in a forging manipulator, which applies screw theory and the reduced system model, is proposed in this paper. The proposed method not only allows a straightforward calculation of actuator forces but also obtains the dynamic equation of the multi-closed-loop mechanism easily. The structure of dynamic model obtained is similar to that of standard Lagrangian formulations, which can extend vast control strategies developed for serial robots to complex multi-closed-loop mechanisms. A complex multi-closed-loop mechanism on a forging manipulator is decomposed into several serial mechanisms or simpler subsystems. The Lagrangian equations associated with each subsystem are directly derived from the local generalized coordinates of the sub-mechanisms. Jacobian matrices are used to interpret the differential equations of the sub-mechanisms into the generalized coordinate or the actuated pairs according to the D’Alembert principle. Hessian matrices are also applied to form a standard Lagrangian formulation. The screw theory is introduced to overcome the difficulties of solving transformed Jacobian matrices, thereby simplifying the calculation of the matrices. Computation difficulties of transformation matrices may decrease considerably by choosing suitable generalized coordinates instead of direct actuator variables. The full dynamics of the complex multi-closed-loop mechanism in a forging manipulator is presented. Simulations and experiments illustrate the reliability of the proposed method and the correctness of the dynamic model of the forging manipulator.

Dynamic Model of a 6-DOF Parallel Mechanism with Hooke's Joints at Both Chain Ends

Conceptual Design and Kinematic Analysis of a New 6-DOF Parallel Mechanism

The Dynamic Model of a New 3-DOF Parallel Mechanism

Kinematic Analysis and Optimization of a Novel 6-DOF Motion Simulator Mechanism.

Stiffness Modeling and Optimization Analysis of a Novel 6-DOF Collaborative Parallel Manipulator.

Dynamic Modeling and Design for the Parallel Mechanism of a Hybrid Type Parallel Kinematic Machine

Design of a Three-Chain 6-DOF Symmetrical Parallel Mechanism and Solutions of Its Forward and Inverse Kinematics

Dynamic Computation of the 6-DOF Parallel Mechanism Based on Kane Method

Dynamic Analysis Of An Over-Constrained Parallel Mechanism With The Principle Of Virtual Work

Kinematic and dynamic analysis of a 3-DOF parallel mechanism

Kinematics Analysis of a Novel Parallel Platform with Passive Constraint Chain

Control-orientated dynamic modeling of forging manipulators with multi-closed kinematic chains

Kinematics and Dynamics Simulation Analysis of a 3-DOF Parallel Mechanism for Application in Hybrid Machine

Closed-Form Dynamic Modeling and Performance Evaluation of a 4-Degrees-of-freedom Parallel Driving Mechanism

Forward Kinematics Analysis and Motion Simulation of a New 6-CCS Parallel Mechanism

Design and Stiffness Analysis of a Class of 2-Dof Tendon Driven Parallel Kinematics Mechanism

Formulation and Evaluation of Coupling Effects Between Dof Motions of Hydraulically Driven 6 Dof Parallel Manipulator

Kinematic and Dynamic Analysis of a New Cylindrical 3-DOF Parallel Manipulator

Kinematic, dynamic, and performance analysis of a new 3-DOF over-constrained parallel mechanism without parasitic motion

Comparison of Two 6-DOF Parallel Mechanisms Based on Kinematic Models

Analysis and Application of a 2-DOF Planar Parallel Mechanism