Abstract:The key to a successful model study is the development of valid similarity requirements. This paper presents an approach to the scale model problem that is different from any previously attempted. An analysis and the interpretation of similarity requirements in a rainfall simulation system is presented, with controlled rainfall intensity and saturated bare land cover to model soil erosion in the small water-shed of Loess Plateau, China. Consequently experimental data on the model and the prototype are used to validate the similarity.In the small watershed of Loess Plateau, usually one run of short but very intense rainstorm could account for most of the total precipitation and soil loss in a year, hence the soil product from the small watershed for a whole year could be simulated by one run of artificial rainfall in laboratory. Soil and water erosion processes of the small watershed were simulated by the immature model with a bare and saturated land cover, while the relative erosion depth which is the ratio of erosion thickness to the length of the watered area, was consistent to that of the prototype, and the landform including the size of the check - dam, was proportional to that of the prototype one. The erosion proportion between the prototype and the model could be deduced according to the relative erosion depth. Each of the models was catena including elemental gemorphological units with characteristics of the typical small watershed in Loess Plateau, and plot 2 # was the normal miniature of plot I #. Homologous matrix loess was used as the erodible material of the two models, and consistent measurement equipments for rainfall, sediment product and runoff were employed in the two models in order to make sure the comparability of the data collected from the prototype and the model. Erosion was monitored by the use of a relief meter inside the plots and, at their outlets, by sampling the discharge. Two series of experiments were conducted in plot I # and plot 2 # respectively. Firstly, each 6 similar to 7 rainfalls with different intensities between 1.0 and 2.0 mm/min was applied in order to find rainfall erosivity of the antecedent land cover of the model and the prototype. Secondly, 10 rainfalls with the same intensity applied on the landscape of the model and the prototype respectively while the twelve dams were orderly constructed. The pre - established rainfall intensity of the model experiment could be calculated by the power function of rainfall intensity to the erosivity according to the converted model sediment product from that in the antecedent landscape. As a result the model soil product converted via the volume scale after each designated rainfall was close to that in the prototype experiment.

Laboratory Rainfall Simulations for Similarity Criterion of Scale Model on Interrill Erosion

Application of Scale Model in Hydrological Frequency Analysis

A Method To Design Scale Model Experiment For Soil And Water Conservation In The Small Watershed Of Loess Plateau, China

Constrained Scaling Approach for Design Rainfall Estimation

Experimental Study of the Impact of Rainfall Characteristics on Runoff Generation and Soil Erosion

Laboratory Studies on the Influence of Rainfall Pattern on Rill Erosion and Its Runoff and Sediment Characteristics

Laboratory rainfall simulation with controlled rainfall intensity and drainage.

Research on the Processes of Rainfall,surface Runoff and Sediment on Sloping Field with Red Loam by Simulated Rainfall Experiment

Influence of Rainfall Infiltration on Slopes by Physical Model Test

Simulated Experiments of Runoff Erosion Modulus Intensity on Slope under Different Land Use Types

Research on Relationships Between Sediment Yield and Hydraulics Parameters on Slope

Research on the Dynamic Processes of Sediment Concentrations in Slope Runoff with Rainfall Intensity and Slope Length

Comparative effects of intermittent and continuous simulated rainstorms on rill erosion based on photogrammetry

Effect strength of rainfall intensity and vegetation coverage on slope erosion and sediment yield

Dynamic Simulation on Hydraulic Characteristic Values of Overland Flow

Effect of Slope Length and Rainfall Intensity on Runoff and Erosion Conversion from Laboratory to Field

Mathematical model of sediment and solute transport along slope land in different rainfall pattern conditions

Development of rill erosion and its simulation with cellular automata-rill model in Chinese Loess Plateau

A Rainwater Redistribution Model to Evaluate Two-Layered Slope Stability after A Rainfall Event

Design of a Pressurized Rainfall Simulator for Evaluating Performance of Erosion Control Practices

Investigation of rainfall‐runoff and sediment yield dynamics under varying slope land use patterns in the Three Gorges Reservoir Area of China