Test and simulation on pull-out behavior of steel wire in concrete

Jiahe Wang,Jun Zhang,Lei Yu,Yuyong Fu

DOI: https://doi.org/10.6052/j.issn.1000-4750.2014.11.0999

2016-01-01

Abstract:A test method for steel wire pulling out from concrete is developed in this paper.The relationship of pull-out load and wire end slippage is obtained.Meanwhile,a micromechanical model of steel wire pull-out from concrete is developed.The interfacial bond parameters are obtained by model calculation.The impacts of embedment length and inclined angles of the steel wire on pull-out performance are analysed.The results show that the pull-out behaviour of steel wire from concrete can be divided into two stages,i.e.,debonding stage and pull-out stage.In the debonding stage,the bonding stress between wire and concrete can be regarded as a constant.In the pull-out stage,the bonding strength between wire and concrete decreases rapidly first and then tends to a constant.For the same curing age,the pull-out peak load and corresponded wire end slippage increase with the embedment length.For the same embedment length pull-out peak load increases with curing age and inclined angles.Good agreement between test and model results is obtained and the pull-out model can be used to predict the pull-out behaviour of steel wire.