Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

An Overview of the Research on Structural Vertical Deformation Occurred in the Construction Process of High-rise Buildings

Theoretical Analysis of Longitudinal Vertical Displacement of Subway Tunnels Caused by the Construction of Steel Casings for Bridge Piles

JOINTS OF MULTI-STORY SPANNED DIAGONAL BRACING SYSTEM IN TALL STEEL BUILDINGS: ANALYSIS AND DESIGN METHOD

Vertical deformation analysis of a high‐rise building with high‐position connections

Study of the influence of shrinkage, creep and temperature difference on super high-rise structural deformation

Research on Section Dimension Optimization of High-Rise Steel–concrete Composite Buildings Based on Improved Dividing Rectangle Algorithm and Combined Response Surface Model

Research on Dynamic Deformation Laws of Super High-Rise Buildings and Visualization Based on GB-RAR and LiDAR Technology

CHARACTERISTICS ANALYSIS FOR HIGH-RISE BUILDINGS DURING TOP-DOWN CONSTRUCTION

Research on Vertical Deformation Difference of Internal and External Tubes During Construction of Guangzhou Pearl River New Town West-tower

Structural Analysis of High-Rise Reinforced Concrete Building Structures During Construction

The Deformation Observation Based on Tai’an Henderson Residential Areas and Forecast Analysis

Research on the Application of an Information System in Monitoring the Dynamic Deformation of a High-Rise Building

Simulation and Deformation Analysis of Construction Process of Large Eccentric Frame‐Core Tube Structure

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Construction simulation of high-rise mixed structure based on model analysis

Estimation of building damage caused by adjacent deep excavation in clay

Research And Analysis of Intelligent Construction Platform Technology for High-Rise Buildings

Deformation characteristics of deep excavations based on mass data

A Review of Key Technologies Development of Super High-Rise Building Construction in China

Stress Development of a Supertall Structure during Construction: Field Monitoring and Numerical Analysis

Large deformation problems arising from deep excavation in silt strata: A case study in Shenzhen, China